|
|
 | | Re: Power to RCX
|
| (...) Sorry, I am little confused. Does it mean that everything LEGO did was REMOVING DC adaptor hole to make difference between 1.0 and 1.5 version ? (talking about RCX hardware) and therefore i can connect my wall AC/DC adaptor directly to that (...) (23 years ago, 11-Feb-02, to lugnet.robotics.rcx)
| | | | | Re: Power to RCX
|
| Success! It works now, and gives 9.2 volts according to the RIS software. You were right, I did have it backwards. Thanks. (...) (23 years ago, 5-Feb-02, to lugnet.robotics.rcx)
| | | | | Re: Power to RCX
|
| Regarding the data sheet for the Melexis MLX1040B that everyone is talking about, and which I've been looking for for years.... This link: (...) (URL) comes back as NOT FOUND The fact that some people are claiming to have seen it implies that it was (...) (23 years ago, 3-Feb-02, to lugnet.robotics.rcx)
| | | | | Re: Power to RCX
|
| "Matthias Jetleb" <Jetleb@Netcom.ca> wrote in message news:3c5b6892.134862...net.com... [snip] (...) Check out this timely post: (URL) this is indeed the same part, then it looks like 12V is the max. (Figure 1 of the datasheet is a little confusing, (...) (23 years ago, 2-Feb-02, to lugnet.robotics.rcx)
| | | | | Re: Power to RCX
|
| I investigated this issue a while back an have taken apart all four of my RCX's (1.0 w. adapter, 1.0 w/o adapter, and 2 2.0's from an RIS1.5 and and RIS2.0). They all have internal voltage regulators. I've written the number down somewhere on this (...) (23 years ago, 2-Feb-02, to lugnet.robotics.rcx)
|
|
