 | | how to unsubscribe
|
|
Greetings everyone, This is a friendly reminder that I, Fred Martin, am the only one who can fulfill your request to be unsubscribed. Therefore, please send such messages to me directly. Remember, that's also how you subscribed in the first place. A (...) (28 years ago, 25-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe handyboard
|
|
unsubscribe handyboard Pamela Jennings ***...*** Pamela Jennings Mind Field Productions pamelaj@panix.com (URL) (28 years ago, 25-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Bootstrap Mode, Problem
|
|
Thank you for the help, It was a cable problem I found a straight thru adapter, and I was able to communicate with the HandyBoard. Thanks again John Pope John.Pope@colorado.edu popej@ucsub.colorado.edu popej@nag.cs.colorado.edu 303-786-4272 (...) (28 years ago, 25-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe handyboard
|
|
unsubscribe handyboard David Zimmerman Hardware Engineer Diamond Lane Communications Corp zimmer@dlcc.com 707.792.2946 x144 (28 years ago, 25-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | Assembly language and the handyboard
|
|
I am planning to use the handyboard with my freshmen in Fall. In addition to the obvious benefits of demonstrating embedded systems, hardware, and robotics, I am interested in using the handyboard as a platform for introducing students to computer (...) (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Bootstrap Mode, Problem
|
|
In your message you said: (...) (1) I assume when you say "miniboard," you actually mean the Serial Interface/Charger board. please be careful with your language because the Mini Board is a different specific project that is not part of the Handy (...) (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Bootstrap Mode, Problem
|
|
Fred, Thank you very much for your response, I was able to complete the first step succesfully(1). However Step 2 does not complete succesfully the Red Led goes off and the green led stays on. Here is how my cables are configured when I hooked up my (...) (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
Please unsubscribe "spectrum@wolfenet.com" from the handy board mailing list. Thanks, (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Bootstrap Mode, Problem
|
|
1. first, check if the board can go into DL mode when it is not attached to the host computer. power on with STOP held down, and it should go into DL mode, indicated by both the BATT and PWR LEDs lighting briefly and then turning off and staying (...) (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)
|
| |
| | Bootstrap Mode, Problem
|
|
I have a handyboard that has been working fine, I pulled it out of a box, where it had sfaely been stored for a month and ran into a problem. I am connecting it to a PC, and using IC v3.1 Beta 3, The Pcode is already on the board. I can get the IC (...) (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)
|
