To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 851
850  |  852
Subject: 
Re: Bootstrap Mode, Problem
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Fri, 25 Oct 1996 00:48:27 GMT
Original-From: 
John R. Pope <popej@nag.csIHATESPAM.colorado.edu>
Viewed: 
3891 times
  
Thank you for the help, It was a cable problem I found a straight thru
adapter, and I was able to communicate with the HandyBoard.

Thanks again


John Pope
John.Pope@colorado.edu
popej@ucsub.colorado.edu
popej@nag.cs.colorado.edu
303-786-4272

On Thu, 24 Oct 1996, Fred G. Martin wrote:

> In your message you said:
> > Fred,
> > Thank you very much for your response, I was able to complete the first
> > step succesfully(1).
> > 
> > However Step 2 does not complete succesfully the Red Led goes off and the
> > green led stays on.
> > 
> > 
> > 
> > Here is how my cables are configured when I hooked up my board to the
> > computer, it is hooked into the
> > 25 pin adapter(in computer), that has 25 to 9 pin then I hooked into a 9 to
> > 25 to hook back to the mini board.  So my cables go 25F to 9M connected
> > to 9F to 25M connected to the miniboard.
> 
> (1) I assume when you say "miniboard," you actually mean the Serial
> Interface/Charger board.  please be careful with your language because
> the Mini Board is a different specific project that is not part of the
> Handy Board system.
> 
> (2) It sounds like your cabling is the source of your problem.  If
> your computer has a 25--pin port, then either (a) plug the Serial
> Interface directly into your computer, or (b) get a
> 25-male-to-25-female straight--through cable and plug the Interface
> board in using that.
> 
> If your computer has a 9-pin serial port, then you want a single
> 9-female to 25-male modem cable.
> 
>  -Fred
> 



Message is in Reply To:
  Re: Bootstrap Mode, Problem
 
In your message you said: (...) (1) I assume when you say "miniboard," you actually mean the Serial Interface/Charger board. please be careful with your language because the Mini Board is a different specific project that is not part of the Handy (...) (30 years ago, 24-Oct-96, to lugnet.robotics.handyboard)

5 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR