Subject:
|
Bootstrap Mode, Problem
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 24 Oct 1996 03:24:32 GMT
|
Original-From:
|
John Pope <JPOPE@WCO.COMihatespam>
|
Viewed:
|
1520 times
|
| |
| |
I have a handyboard that has been working fine, I pulled it out of a box,
where it had sfaely been stored for a month and ran into a problem.
I am connecting it to a PC, and using IC v3.1 Beta 3, The Pcode is
already on the board. I can get the IC to recognize the board and the
fact that it is attached to a com port, 2. However I cannot get the
computer to synchronize with the board. I figured I should replace the
pcode, but I can't even get the board into the download mode. I press the
stop button and hold it down while I turn on the board, then the batt led
turns off put the green pwr led still stays lit even after I have held the
stop button down for a minute or longer, the lcd goes faint with the
blocks across the top shaded in.
So does anyone have any suggestions of solutions to my problem, or things
I can try in order to get it to work.
John Pope
John.Pope@colorado.edu
University of Colorado at Boulder
Computer Science Student.
|
|
Message has 1 Reply: | | Re: Bootstrap Mode, Problem
|
| 1. first, check if the board can go into DL mode when it is not attached to the host computer. power on with STOP held down, and it should go into DL mode, indicated by both the BATT and PWR LEDs lighting briefly and then turning off and staying (...) (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|