To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 848
847  |  849
Subject: 
Re: Bootstrap Mode, Problem
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Thu, 24 Oct 1996 22:25:56 GMT
Original-From: 
Fred G. Martin <fredm@media.STOPSPAMmit.edu>
Viewed: 
1696 times
  
In your message you said:
Fred,
Thank you very much for your response, I was able to complete the first
step succesfully(1).

However Step 2 does not complete succesfully the Red Led goes off and the
green led stays on.



Here is how my cables are configured when I hooked up my board to the
computer, it is hooked into the
25 pin adapter(in computer), that has 25 to 9 pin then I hooked into a 9 to
25 to hook back to the mini board.  So my cables go 25F to 9M connected
to 9F to 25M connected to the miniboard.

(1) I assume when you say "miniboard," you actually mean the Serial
Interface/Charger board.  please be careful with your language because
the Mini Board is a different specific project that is not part of the
Handy Board system.

(2) It sounds like your cabling is the source of your problem.  If
your computer has a 25--pin port, then either (a) plug the Serial
Interface directly into your computer, or (b) get a
25-male-to-25-female straight--through cable and plug the Interface
board in using that.

If your computer has a 9-pin serial port, then you want a single
9-female to 25-male modem cable.

-Fred



Message has 1 Reply:
  Re: Bootstrap Mode, Problem
 
Thank you for the help, It was a cable problem I found a straight thru adapter, and I was able to communicate with the HandyBoard. Thanks again John Pope John.Pope@colorado.edu popej@ucsub.colorado.edu popej@nag.cs.colorado.edu 303-786-4272 (...) (28 years ago, 25-Oct-96, to lugnet.robotics.handyboard)

Message is in Reply To:
  Re: Bootstrap Mode, Problem
 
Fred, Thank you very much for your response, I was able to complete the first step succesfully(1). However Step 2 does not complete succesfully the Red Led goes off and the green led stays on. Here is how my cables are configured when I hooked up my (...) (28 years ago, 24-Oct-96, to lugnet.robotics.handyboard)

5 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR