 | | Re: How many 5 wire steppers?
|
|
Hello, From the book "Mobile Robots -- Inspiration to implementation", there is a circuit that used to sample the noise level from the mic. It also comes with Interactive-C source code. I guess this is what you are looking for. Thanks. Patrick Hui (...) (23 years ago, 14-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | Phasing Errors and as11
|
|
Has anyone managed to sort out all the "phasing errors" you get when you try to reassemble pcode v3.1 using as11? Thanks, George Musser georgejr@musser.com (23 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | How many 5 wire steppers?
|
|
I have a Handyboard with the expansion board. I'm building an interactive sculpture with the board. This is my first use of my Handyboard. I would like to hook up five or six stepper motors to the board. The motors I'm using are scrapped from old (...) (23 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Beginners Quest.
|
|
The E1 chip works with the Handy Board. Actually, any of the 52-pin PLCC 6811s will work. You may have to change the CONFIG register to get Interactive C to run. Fred (...) (23 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | Pyro sensor
|
|
Hi! Does anyone has implemented a person following behavior? If so I would appreciate any hardware or software details. If I'm not wrong, I can modify one of those PIR detectors used with burglar alarms as it has the sensing element and amplifiers (...) (23 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Beginners Quest.
|
|
Well, I almost sure that you have to use the A1, the other chips have a different configuration, like they can have an eeprom. (23 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | Beginners Quest.
|
|
Hi all there, Plz can somebody tell me if I can use MC68HC11E1, E0 or F1 chip instead of HC11A1. I've just looked into archives and found nothing about that. Thx for help. (23 years ago, 12-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | Re: two Qs
|
|
Hi, (...) (int (...) Yes. You still can use motor library to control the speed if using separate motor supply. (...) You can check the following link: (URL) Regards, Patrick Hui (URL) (23 years ago, 11-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | Re: two Qs
|
|
Q.1) Yes. Q.2) I don't know this sensor. Bye. (23 years ago, 11-Jun-01, to lugnet.robotics.handyboard)
|
| |
| | two Qs
|
|
Hello... I'd like to ask two questions regarding my H.B; Q.1) If I cut the motors power-trace on the H.B to connect an external 24 volt dc power supply. Would I still be able to control the speed and direction of the motors by software using the (...) (23 years ago, 11-Jun-01, to lugnet.robotics.handyboard)
|
