To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 8407
8406  |  8408
Subject: 
Re: Beginners Quest.
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Wed, 13 Jun 2001 15:27:56 GMT
Viewed: 
1599 times
  
Well, I almost sure that you have to use the A1, the other chips have a
different configuration, like they can have an eeprom.



Message has 1 Reply:
  Re: Beginners Quest.
 
The E1 chip works with the Handy Board. Actually, any of the 52-pin PLCC 6811s will work. You may have to change the CONFIG register to get Interactive C to run. Fred (...) (23 years ago, 13-Jun-01, to lugnet.robotics.handyboard)

Message is in Reply To:
  Beginners Quest.
 
Hi all there, Plz can somebody tell me if I can use MC68HC11E1, E0 or F1 chip instead of HC11A1. I've just looked into archives and found nothing about that. Thx for help. (23 years ago, 12-Jun-01, to lugnet.robotics.handyboard)

3 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR