To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 8409
8408  |  8410
Subject: 
Re: Beginners Quest.
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Wed, 13 Jun 2001 21:09:31 GMT
Viewed: 
1836 times
  
The E1 chip works with the Handy Board.  Actually, any of the 52-pin
PLCC 6811s will work.  You may have to change the CONFIG register to get
Interactive C to run.

Fred

On Wednesday, June 13, 2001, at 04:27 PM, Rodrigo Cruz wrote:

Well, I almost sure that you have to use the A1, the other chips have a
different configuration, like they can have an eeprom.




Message is in Reply To:
  Re: Beginners Quest.
 
Well, I almost sure that you have to use the A1, the other chips have a different configuration, like they can have an eeprom. (23 years ago, 13-Jun-01, to lugnet.robotics.handyboard)

3 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR