To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 8405
8404  |  8406
Subject: 
Re: two Qs
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Mon, 11 Jun 2001 23:43:30 GMT
Viewed: 
2949 times
  
Hi,

I'd like to ask two questions regarding my H.B;

Q.1) If I cut the motors power-trace on the H.B to connect an external 24
volt dc power supply. Would I still be able to control the speed and
direction of the motors by software using the library function, "motor • (int
m, int p)"?

Yes. You still can use motor library to control the speed if using separate
motor supply.

Q.2) The time I connect the new power source to the 4-pin motor
power-expansion header, where can I connect the Polaroid (6500 ranging
system) power supply cable? I have no expansion board...it is connected to
the H.B directly.


You can check the following link:

http://www.handyboard.com/software/sonar.html

Best Regards,

Patrick Hui
http://www.robotstorehk.com



Message is in Reply To:
  two Qs
 
Hello... I'd like to ask two questions regarding my H.B; Q.1) If I cut the motors power-trace on the H.B to connect an external 24 volt dc power supply. Would I still be able to control the speed and direction of the motors by software using the (...) (23 years ago, 11-Jun-01, to lugnet.robotics.handyboard)

3 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR