|
| |
|   sensors (score: 0.368) |
|
 | | Re: Teaching with Mindstorms
|
| (...) Dacta (Lego's educational branch) sells a number of Mindstorms products, including Robolab - a programming environment that's significantly better than the normal Mindstorms environment. They also have a couple of RCX based sets aimed (...) (28 years ago, 21-Mar-99, to lugnet.robotics)
| |
|   sensor, sensors (score: 0.368) |
|
 | | Service pack 5111 - Wires - no longer available
|
| I was very upset to discover that LD have withdrawn 5111 worldwide, when I recently tried to place an order for more. Please note that this puts an end to 3rd party sensors :( I had asked LD to be polite enough to email me a warning that they were (...) (24 years ago, 2-Sep-02, to lugnet.robotics)
| |
|   sensors (score: 0.368) |
|
 | | Re: Help: RCX 1.0 power adapter
|
| Your comment intrigued me into checking. I grabbed a couple of transformers and checked them (with a 4 1/2 digit true rms meter). Off load (open circuit) one reads 10.4v a/c, the other 10.9v a/c. That is well within Lego's 9 - 12v a/c spec. JB (...) (24 years ago, 31-Aug-02, to lugnet.robotics)
| |
|   sensors (score: 0.368) |
|
 | | Re: Mindstorms vs. Cybermaster
|
| (...) The programming environment of the RCX is more powerful, starting by the fact that you can replace the original firmware. Using the standard firmware, the RCX have about 10 times more memory than the CyberMaster. With the RCX you can also (...) (28 years ago, 19-Mar-99, to lugnet.robotics)
| |
|   sensor, sensors (score: 0.368) |
|
 | | Using the DC to DC converter
|
| Hi, I intend to use a 5V source battery going thru a DC to DC converter to get a 12V source. Then this 12v will connect to my diffuse sensor which operrate at 12V. The sensor's current consumption maximum is 35mA. If the output Watt of the DC-DC (...) (28 years ago, 18-Mar-99, to lugnet.robotics.handyboard)
| |
|   sensor, sensors (score: 0.368) |
|
 | | Re: Help: RCX 1.0 power adapter
|
| I use Radio Shack 273-1631. I have a number of these and I have been using them for a couple of years. These devices have a voltage selector switch which I set to 9v. In fact, I wedge a short length of wooden tooth-pick in the switch slot to avoid (...) (24 years ago, 31-Aug-02, to lugnet.robotics)
| |
|   sensors (score: 0.368) |
|
 | | Using sensor ports to send data
|
| Hello, I did build an I2C device for the RCX a while ago, which is connected to the motor ports of the RCX. It now makes a speed of about 1.2kHz when using BrickOS (still thanks to Mark Riley for helping me whit this). But i think the sensor-ports (...) (23 years ago, 20-Jun-03, to lugnet.robotics)
| |
|   sensor (score: 0.368) |
|
 | | Re: Iveco Eurostar with extensible trailer
|
| Its very very simple how the steering works. If you ever have taken a good look on the fifth wheel on a truck, (europian ones not sure about US trucks) there are a little cutout piece in the rear, and behind the king pin (the pin on the trailer (...) (24 years ago, 11-Sep-02, to lugnet.technic, lugnet.robotics)
| |
|   sensors (score: 0.368) |
|
 | | Re: Continous operation
|
| (...) Not only that: it also allows for a lot of freedom in creating your own sensors and devices! I love that Mindstorms stuff! Remko "Gosh, I gotta get a life!" ;) (24 years ago, 9-Sep-02, to lugnet.robotics.rcx)
| |
|   sensors (score: 0.368) |
|
 | | Re: Iveco Eurostar with extensible trailer
|
| (...) Hi Jennifer Im happy in your reply. You, Dennis,Bram and Evert are my favourite builders in this NG.. I prefer technic figure scale in heavy vehicle so its easy to have motion in various function. Then I add Mindstorms special parts (special (...) (24 years ago, 10-Sep-02, to lugnet.technic, lugnet.robotics)
| |
|   sensors (score: 0.367) |
|
 | | Re: Use RCX motor output to switch devices
|
| In response to the following, Ran Talbot e-mailed me. (...) "A "full-wave bridge rectifier" (as used in AC-to-DC power supplies) will do that nicely. I believe some of the Lego "active" sensors do this. I don't know if anyone makes an AC (...) (24 years ago, 8-Sep-02, to lugnet.robotics)
| |
|   sensors (score: 0.367) |
|
| |
|   sensors (score: 0.367) |
|
 | | Re: Using the DC to DC converter
|
| (...) Yes, P=VI. When the Specification sheet says the converter can source 1W, they mean at most 1 Watt. When your sensor says it consumes 35mA, this is again the max and only if the 12V is supplied. If less than 12V is supplied it will probably (...) (28 years ago, 18-Mar-99, to lugnet.robotics.handyboard)
| |
|   sensor, sensors (score: 0.367) |
|
 | | Sensors
|
| hi i'm trying to find a cheap and reliable infra-red digital sensor with a sensing range of around 0-30cm. does anyone have any recommendations? are there any online stores that sell a wide variety of such sensors? btw, the sharp GP2D05/02 sensors (...) (28 years ago, 12-Mar-99, to lugnet.robotics.handyboard)
| |
|   sensor, sensors (score: 0.367) |
|
 | | Switching Direction
|
| I have a motor which drives a rack mechanism and I'm using a rotation sensor to index my position on the rack. When I program the motor (in NQC) to go forward I want the sensor to count up. If the sensor then actually goes down I want to test for (...) (23 years ago, 18-Jun-03, to lugnet.robotics)
| |
|   sensor (score: 0.367) |
|
 | | Touch Switch 2974
|
| (...) metallic (...) with (...) I was fortunate enough to find one of these on BrickLink and it just came in today. It turns out the resistance is 2.2K and I suspect the contacts are metal since the resistance doesn't seem to vary with pressure. (...) (23 years ago, 28-Jun-03, to lugnet.robotics.rcx)
| |
|   sensor (score: 0.367) |
|
 | | Re: mindstorm 1.5 price
|
| (...) Yep, $75 sounds good. Make sure the electric parts are all there (RCX, motors, sensors, tower, etc.) You can find the inventory here: (URL) Mindstorms group is .robotics, there are sub groups for additional focus: (URL) (24 years ago, 5-Sep-02, to lugnet.technic, lugnet.robotics)
| |
|   sensors (score: 0.367) |
|
| |
|   sensors (score: 0.367) |
|
 | | Re: Service pack 5111 - Wires - no longer available
|
| I just decided to post a "everyone please calm down" message when yours came through. I am pleased that someone, somewhere, moved to stop the alarm. Of course, I wish I knew what they said! There just isn't a lot of evidence that MindStorms is going (...) (24 years ago, 3-Sep-02, to lugnet.robotics)
| |
|   sensors (score: 0.367) |