| |
In lugnet.general, Jonathan Brown writes:
> Hi Marco
>
> The RCX is slung underneath the "glider" (actually a 2 meter delta stunt • kite). It has
> one micromotor plugged into OUT_B (i.e., the micromotor contacts are fitted • directly onto
> the OUT_B contacts so the center of the motor's rotation is vertically • upwards). A cam is
> fitted on top of the mocromotor with 2-stud axle -- the far end of the cam is • attached to
> bridle lines which go to the left and right spars of the delta.
>
> I don't directly control the RCX, it is programmed to to stay straight for one • second, and
> then shift the cam slightly to the left -- this shifts the wieght of the RCX • relative to
> the center of gravity of the kite, thus putting the kite into a banking • spiral. The RCX
> also beeps every half second so that I have a way of calculating the flight • time. If you
> want more info, I can post a dat of the RCX to one of the CAD sections.
>
> Cheers
>
> JP
Hi Jonathan
I am a very curious man and so ... here are some question for you :)
Are you sure the micromotor has enough power to move the rcx while flying?
Why you want the kite to enter a spiral dive after just one second flight?
Why do not try instead to use the rcx to try to keep the kite in a straight
flight ?
Bye
Marco
|
|
Message is in Reply To:
 | | Re: LEGO RCX Skydivers
|
| Hi Marco The RCX is slung underneath the "glider" (actually a 2 meter delta stunt kite). It has one micromotor plugged into OUT_B (i.e., the micromotor contacts are fitted directly onto the OUT_B contacts so the center of the motor's rotation is (...) (25 years ago, 6-Nov-99, to lugnet.general, lugnet.robotics)
|
22 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
