To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 451 (+10)
  Re: RCX Programming Questions and Sensor Ideas
 
(...) I think "oops" applies in this case. Your fix looks correct. (...) It doesn't have to be random, just each task needs a different delay. This is easy, since each task has to run its own version of the code. For task 3 insert 3 noops, for task (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  Re: Ultrasonic Radar
 
(...) Polaroid manufactures the 6500 series ultrasonic ranging system that can be purchased in single quantities for less than $50 US, but it can't be directly connected to the RCX. (See (URL) for ordering. See ftp://wirz.com/Polar...r/6500.PDF for (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  What about multiplexing sensors?
 
Has anyone attempted to mux the three sensor connections to expand the RCX's sensor capability? Think this is possible? I don't have an RCX of my own [yet] nor the EE capacity to pull this off, so I'm counting on the geniuses out there! --Steve (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  Re: MindStorms at Robot Store (Hacking Lego Compatible Parts)
 
I have some black ones as well, I think its for colour coding - yellow for sensors, black for third motor. I think I prefer the old grey cable as its more flexible. Perhaps the stiff thin black cable is supposed to last longer. On the Cybermaster (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  Re: RCX Programming Questions and Sensor Ideas
 
(...) Does that support an arbitrary number of tasks? If there are n tasks numbered 1 to n, and task k delays for k cycles on failure, I think you still have to be careful to make sure that the number of tasks n is smaller than the loop overhead h (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  Tachocount
 
According to the Technical Reference, Tachocount counts the number of revolutions of the motor shafts (of the two built-in Cybermaster motors ONLY). I fiddled a liitle with it, but it doesn't seem too useful, first of all because the internal motors (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  Re: Tachocount
 
At least there's one thing that CyberMaster proved - That 3 inputs is not the limit of the H8 or even all the LEGO PBricks. Clearly CyberMaster have 5 inputs, although 2 of them are fixed just like the 2 fixed motors (which is not as bad as it (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  RE: MindStorms at Robot Store (Hacking Lego Compatible Parts)
 
Here's a piece I could use: a touch sensor (switch) that is normally closed, with a diode in it. The diode could also be separate, in a brick with contacts on the top and the bottom, so you can stack the sensor, the diode, and your hookup wire. It (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  Re: What about multiplexing sensors?
 
You can: 1. Put multiple Touch sensors on the same input but you can't tell which one was hit. 2. Put a Light and Touch sensor on the same input and read normal light levels except when the Touch is hit it the input will read 100. 3. There are a (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
 
  RE: What about multiplexing sensors?
 
I'm thinking more along the lines of using all three outputs and all three inputs to code a multi (read "more than three of each input and/or output") I/O multiplexor? This inherently reduces the possible sample rate on each input or output (...) (28 years ago, 11-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR