To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 4491 (+10)
  re: legOS for the helpless
 
=>From: David Chen <nospam-dcchen@pacbe...et-nospam> =>... =>Since (I assume) there are many out there who are having a really tough =>time getting a working LegOs development environment working on their =>various systems (Mac, Winblows, etc...), (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  (canceled)
 
 
  rpm of the Geared motor
 
Anyone know the rpm of the Geared motor. Thanks LINC (28 years ago, 9-Apr-99, to lugnet.build, lugnet.robotics)
 
  Re: Even more remote controls
 
there are a few sites out there wif the required IR info.. I'll try and dig em up tomorrow morning.. I'm gonna get my self a blank GB cart, and the device to upload the data to the cart hopefully this comming friday.. -----Original Message----- (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  RE: rpm of the Geared motor
 
# From: ldsmith@pfc.forestry.ca # Sent: 09 April 1999 07:44 # To: lego-robotics@crynwr.com # Subject: rpm of the Geared motor # ---...--- # Anyone know the rpm of the Geared motor. # If you mean the one that comes with the RIS, it's 350. When I (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  Re: rpm of the Geared motor
 
(...) About 360 rpm, according to my measurements. The non-geared motor runs at about 4200 rpm. (...) Regards, Johannes. (28 years ago, 9-Apr-99, to lugnet.build, lugnet.robotics)
 
  Re: Even more remote controls
 
(...) Since you can control the IR LED directly you should be able to get this all working in SW. You will need to modulate the IR with a 40Khz carrier. From there you then turn on and off the carrier to create the start, data and stop bits. This is (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  On 9V battery box #5391 for projects
 
I recently got a 5391 9V battery box from S@H to put my RCX IRPD board into. I cut off all but 3 nubs worth of the box from the end with the switch and removed the battery tensioner at that back. The board fits in nicely with just the LEDs sticking (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  Re: On 9V battery box #5391 for projects
 
(...) DOH! (URL) FRIDAY!!! (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  Re: 4WD 4WS model w/limited slip diff.
 
This photo might help (2 URLs) the rubber-band connection between the two power outputs, whenever the model would go over a bump and one wheel was lifted off the ground, the other wheel would not spin at all and all the power went to the other (...) (28 years ago, 9-Apr-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR