 | | Re: Contest
|
|
With the restriction that there are no obstacles in the room, the robot could use the IR-Radar scheme that has been discussed to probe around. If it found an obstacle that was only a couple of inches wide it would know that it was a coke can and not (...) (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Contest
|
|
The Dallas robotics group has a similar contest. We can adapt our rules from theirs if needed. (...) Joel Shafer joel@connect.net -- Did you check the web site first?: (URL) (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Contest
|
|
An interesting proposal. (...) I would presume that adding a third motor (like for a gripper to pick up a Coke can) would constitute a non-RIS only solution, since the RIS only comes with two motors? Although I guess you could capture the can with (...) (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Contest
|
|
I like it! LINC (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Contest
|
|
Good point - there were only 2 motors. It would be better if it were multiple cans as well. The scoring system on that Dallas contest web page ((URL) looked pretty good to me. It is an interesting problem to drive the bot and pick up the can with (...) (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: flames
|
|
mac wrote: Having had 'my' say I will cease to waste your time ^^^^^ uh... that should be 'waist'. :) ha ha ha. i couldn't resist. and, yes, i know i'm wrong. (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Contest
|
|
Let's have a couple of classes of competition. Unlimited class is anything goes. Basic class will be the basic Mindstorm set + one motor. Perhaps we should define a class in between as well. We will have to define the size of the room to prevent a (...) (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Contest
|
|
Remember the bit about the new Lego Star wars robot thing - Where you have a setting so that forward drives the motor and backward closes the claw? That's one motor. Set up another like in artoflego.pdf with that flat gear (and the worm gear I (...) (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | RE: Contest
|
|
A contest would be an interesting idea, but would it be limited to what you can achieve with a single RIS kit? I have two and the parts are so thoroughly intermixed now, that I couldn't know with any certainty if the elements I used in the (...) (28 years ago, 23-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Contest
|
|
It isn't actually that tough to do it with two motors. I can think of two ways off of the top of my head. 1) Motor I - Drives both treads forwards, only drives one backwards Motor II - grabbing the can 2) Motor I - Drives left tread forwards, (...) (28 years ago, 23-Feb-99, to lugnet.robotics)
|