Subject:
|
Re: C++ compiler for dos
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 21 Jan 1999 14:53:19 GMT
|
Viewed:
|
1251 times
|
| |
|
|
Hi,I have the HP 200LX palm top.
Its CPU is 80C186.
And I tried to compile NQCC to 186.
But 16bit RS232C routine "termios.h" is not compatible to 8bit compiler.
There are two ways to contorol from 8bit dos system.
One, create "termios.h" compatible routine.I think it is very difficult.
Another,use Peter Hasketh Project. He made a dos qbasic program to send
commands to RCX.
http://www.phesk.demon.co.uk/lego/index.htm
|
|
Message has 2 Replies:
 | | RE: C++ compiler for dos
|
| Which compiler did you use? I have been unable to obtain a C++ compiler that targets 286 (or below) that will accept templates. I am willing to go a long way to write the serial comms stuff needed to get this up and running. Simen (...) -- Did you (...) (26 years ago, 21-Jan-99, to lugnet.robotics)
| | | Re: C++ compiler for dos
|
| Sorry,I mistook. (...) But 32bit RS232C routine "termios.h" is not compatible to 16bit compiler. (...) There are two ways to control from 16bit dos system. (26 years ago, 21-Jan-99, to lugnet.robotics)
|
Message is in Reply To:
| | C++ compiler for dos
|
| I am planning to port NQCC to DOS to use an old Laptop I have to program my bots. My old laptop has an ancient 286 processor so I have trouble locating a proper compiler that can target it. I don't mind if the compiler itself needs to run on a dual (...) (26 years ago, 19-Jan-99, to lugnet.robotics)
|
7 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
