Subject:
|
RE: C++ compiler for dos
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 21 Jan 1999 15:13:06 GMT
|
Original-From:
|
Simen Svale Skogsrud <{simen@mop}spamcake{.no}>
|
Reply-To:
|
<simen@mop.STOPSPAMMERSno>
|
Viewed:
|
1274 times
|
| |
|
|
Which compiler did you use? I have been unable to obtain a C++ compiler that
targets 286 (or below) that will accept templates. I am willing to go a long
way to write the serial comms stuff needed to get this up and running.
Simen
> -----Original Message-----
> From: news@lugnet.com [mailto:news@lugnet.com]On Behalf Of Tetsuro
> Makise
> Sent: 21. januar 1999 15:53
> To: lego-robotics@crynwr.com
> Subject: Re: C++ compiler for dos
>
>
> Hi,I have the HP 200LX palm top.
> Its CPU is 80C186.
> And I tried to compile NQCC to 186.
> But 16bit RS232C routine "termios.h" is not compatible to
> 8bit compiler.
>
> There are two ways to contorol from 8bit dos system.
> One, create "termios.h" compatible routine.I think it is very
> difficult.
> Another,use Peter Hasketh Project. He made a dos qbasic
> program to send
> commands to RCX.
> http://www.phesk.demon.co.uk/lego/index.htm
> --
> Did you check the web site first?: http://www.crynwr.com/lego-robotics
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: C++ compiler for dos
|
| Hi,I have the HP 200LX palm top. Its CPU is 80C186. And I tried to compile NQCC to 186. But 16bit RS232C routine "termios.h" is not compatible to 8bit compiler. There are two ways to contorol from 8bit dos system. One, create "termios.h" compatible (...) (26 years ago, 21-Jan-99, to lugnet.robotics)
|
7 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
