To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 2626 (+20)
  Re: Now I have a (small) Cybermaster page too
 
Hi Anders, Nice robot! I like your bumper design, how does it perform at frontal impact? Great idea: having the 'tilt bumper' at the back of the robot!! CU Bert Visit my site on Lego, Robot's and Visual Basic at (URL) bericht----- Van: Anders (...) (28 years ago, 10-Jan-99, to lugnet.robotics)
 
  Re: Now I have a (small) Cybermaster page too
 
B van Dam skrev i meddelandet <006d01be3cdf$a1fc69...an-dam>... (...) If the front 'tube' (what's it really called?) hits, both sensors are activated, and the robot backs up a bit, and turns (this function was what caused the need for NQC - can't (...) (28 years ago, 10-Jan-99, to lugnet.robotics)
 
  Re: cool idea for all-around range sensor
 
Have you devised some way for the output of each IR receiver to be bistable as opposed to analog ? In order to wire-or a bunch of them with resistors and get a unique, repeatable reading for each receiver being "active" would require two stable (...) (28 years ago, 10-Jan-99, to lugnet.robotics)
 
  Re: cool idea for all-around range sensor
 
sounds interesting. i figured i was oversimplifying it. but i've seen bots with 24 sonar sensors around the machine. since most controllers dont have 24 input ports, there's probably a round robin action going on, pulsing between each of the 24 (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: Self learning robot with neural brain
 
You can get the control creation edition of VB5 for free. It will allow you to write software, you just can't compile a stand alone executable. It seems to work just fine with spirit.ocx. I can't remember the exact link, but you should be able to (...) (28 years ago, 10-Jan-99, to lugnet.robotics)
 
  Re: Self learning robot with neural brain
 
I don't have to worry about the size (I have a cable modem :) ), I just need to know if I can still run the neural net program without a compiler. -Chris Joel Kunze wrote in message ... (...) seems (...) you (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: Self learning robot with neural brain
 
I don't see any reason why it would not work. It is just that you have to have the visual basic environment running at the same time, sometimes a little clumsy, but still functional. I use the control creation edition for various things like (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Book on Robot Sensors and Navigation Techniques.
 
Thanks to Carl Schaefer for posting the URL for the Robotics Reference entitled: Where am I? Sensors and Methods for Mobile Robot Positioning by J. Borenstein , H. R. Everett , and L. Feng I have looked into the Table of Contents and have begun (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Cut Price Mindstorms in the UK...
 
I hate - and I do mean *HATE*, paying full price for anything and would like to get a couple of Mindstorms kits for educational purposes (OK, OK, I'm going to play with them) but everywhere I look [here in the UK] has them at the full RRP of (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  More small changes to firmdl.c
 
Two more small changes to firmdl.c. Gavin Smyth reported seeing long delays while downloading firmware, and suggested a fix that may or may not have much effect, depending on your system. That fix, which limits the number of response bytes waited (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: RCX 2.0 -- ideas.
 
(...) I'd take a couple if they were in the $15 dollar range. -Blake -- Did you check the web site first?: (URL) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Fw: RcxCC Joystick controls
 
Very simple. Write a little nc program that defines some tasks. Download it to the robot but don't run it. Here is a trivial example. After downloading it, the first button will start motor B and the second button will stop it. (Note that the order (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: Pneumatic Tanks
 
(...) :-) (...) Syringes? That's injection needles, right? Hm. Now where do I get disposable syringes? Ah, I figure I'll find something I can use somewhere. Thanks for the idea! Fredrik (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: ideas?
 
This should have worked - are you sure that you replaced your old Menus folder with the one in the extras folder? see ya (...) Associate Professor Department of Mechanical Engineering Tufts University Medford, MA 02155 email: crogers@tufts.edu (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: Book on Robot Sensors and Navigation Techniques.
 
As long as we're on the subject of books, I'd like to recommend "Mobile Robots" by Anita Flynn and Joe Lee Jones: (URL) a fascinating book, full of hands-on information. It contains step by step instructions for building several robots, including (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: Pneumatic Tanks
 
Fredrik Glöckner wrote in message ... (...) Yes, injection needles. Make sure to get a small gauge needle. Since the air is thin, you need a small restriction to see any reduction in flow. Drug stores normally have disposable needles, but you might (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: The Ten Commandments of Lego
 
What happened to Thou shalt not glue Lego? (...) -- Technical Support requests should be sent to support@opendisc.com Joe Greene Technical Support OpenDisc Systems, Inc. Boulder, Colorado, 80301-2442 USA 303-546-0460 Joe_Greene@OpenDisc.Com (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: Using a standard remote control with the RCX
 
Hey Eric, You might have to send the "send RCX" command to the remote to allow it to contact the RCX. ALso, it will not be able to send confirmation to the RCX when the RCX starts with the protocol response or some such thing. (...) ---...--- (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  LEGO Robot Arena page is up
 
Hello, I've put up a page describing my upcoming Mindstorms robot fighting tournament in San Jose, California: (URL) also received some e-mail from someone who is interested in an east coast event (Sarasota, Florida). If you're on the EAST coast and (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  IR Port to RCX
 
Hi Gang, I was jujst wondering if anybody has used the IR port on a notebook to talk to the RCX as opposed to the IR tower. Just curious. Nick (28 years ago, 11-Jan-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR