Subject:
|
Re: Dual Hex small piston compressor (repost)
|
Newsgroups:
|
lugnet.technic, lugnet.robotics
|
Date:
|
Mon, 29 Aug 2005 01:58:49 GMT
|
Reply-To:
|
Geoffrey Hyde <gDOThyde@bigpondDOTnetDO#stopspammers#Tau>
|
Viewed:
|
290 times
|
| |
|
|
"Kevin L. Clague" <kevin_clague@yahoo.com> wrote in message
news:ILI0oC.1DE4@lugnet.com...
> In lugnet.technic, Steve Lane wrote:
> Hi Steve,
> I literally mean broken. I changed some of the beams to get a different
> color, and in thbe process created a hose cutter (not unlike a paper
> cutter) and
> unwittingly sliced hoses.
>
> Once fixed, I never had problems with hoses popping off. I made sure to
> use new
> hose.
Do you think you could develop the hose cutter accidentally built a bit more
to make something that could automatically cut pneumatic tubing to length?
Was the cut sharp and at 90 degree angles to the hose end, or did it come
out jagged and at an odd angle? The worst possible thing that could happen
IMHO, would be bad, angular hose ends that slide on and force one to make
the hoses angle a bit on the plastic connector block instead of being
straight and true.
--
Cheers ...
Geoffrey Hyde
|
|
Message has 1 Reply:
Message is in Reply To:
9 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
