Subject:
|
Re: Dual Hex small piston compressor (repost)
|
Newsgroups:
|
lugnet.technic, lugnet.robotics
|
Date:
|
Mon, 29 Aug 2005 12:23:13 GMT
|
Viewed:
|
278 times
|
| |
|
|
In lugnet.technic, Geoffrey Hyde wrote:
>
> "Kevin L. Clague" <kevin_clague@yahoo.com> wrote in message
> news:ILI0oC.1DE4@lugnet.com...
> > In lugnet.technic, Steve Lane wrote:
> > Hi Steve,
> > I literally mean broken. I changed some of the beams to get a different
> > color, and in thbe process created a hose cutter (not unlike a paper
> > cutter) and
> > unwittingly sliced hoses.
> >
> > Once fixed, I never had problems with hoses popping off. I made sure to
> > use new
> > hose.
>
> Do you think you could develop the hose cutter accidentally built a bit more
> to make something that could automatically cut pneumatic tubing to length?
> Was the cut sharp and at 90 degree angles to the hose end, or did it come
> out jagged and at an odd angle? The worst possible thing that could happen
> IMHO, would be bad, angular hose ends that slide on and force one to make
> the hoses angle a bit on the plastic connector block instead of being
> straight and true.
Hi Geoffrey,
It was neither kind of cut. It merely did a partial cut of the hose. THis is
worse because it is not as evident.
Kevin
|
|
Message is in Reply To:
9 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
