Subject:
|
Re: Dual Hex small piston compressor (repost)
|
Newsgroups:
|
lugnet.technic, lugnet.robotics
|
Date:
|
Tue, 16 Aug 2005 05:37:34 GMT
|
Viewed:
|
4464 times
|
| |
|
|
In lugnet.technic, Kevin L. Clague wrote:
> In lugnet.technic, Paul Krieg wrote:
> > Hi Kevin,
> > Your compressor is very nice. I am fascinated by your crank. I hope I am
> > seeing it right. It seems a very clever way of getting the amount of travel
> > right and allowing the use of those pulleys with cross holes to connect all the
> > piston rods to the crank. The 2 halfs of your compressor look as though they
> > can run independently of one another. Is this true, or are they some how
> > mechanicaly connected? Thank you for sharing it.
>
>
> Hi Paul,
> THanks for the feedback on the compressor.
>
> Yes. There are actually two independent compressors that share the same
> structure.
While at Brickfest, Nathan shared his knowledge of radial engines with me. My
future radial designs will have an odd number of evenly spaced pistons/pumps.
I knew that one critical issue was that the piston shaft needs to point at the
axle of rotation when the piston is completely expanded and completely
contracted. After much use at Brickfest, my dual hex no longer did this.
I will be remodling it to try to make a tri-pump design to see if helps this
geometry.
>
> > Regards, Paul
>
> Kevin
Kevin
|
|
Message has 1 Reply:
Message is in Reply To:
9 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
