 | | Re: Problem with auto-steering mechanism. —Steve Hassenplug
|
| | | (...) I find it hard to believe some 'iffy' condition would be required for a mass-producted childs toy. (so you hope) I have two suggestions. 1) Limit the rotation of the turntable to 180 degrees. (or 180 each direction) That should keep it from (...) (22 years ago, 25-Oct-02, to lugnet.robotics)
|
| | | |
| | | | | Re: Problem with auto-steering mechanism. —Steve Baker
|
| | | | (...) Yeah - exactly. (...) Limiting the rotation like that would remove the very feature of this mechanism that I need - the ability to escape (eventually) from any kind of corner. (...) That might work - but it comes into the catagory of 'iffy' (...) (22 years ago, 25-Oct-02, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Problem with auto-steering mechanism. —Brian B. Alano
|
| | | | (...) I made a flimsy mini-rover version of Ben Jackson's rover a while back. Note the use of iffy friction in the rear by barely inserting an axle into a micromotor pulley: (URL) front wheels are offset from the vehicle's center line to counter the (...) (22 years ago, 27-Oct-02, to lugnet.robotics)
|
| | | | |
| | | | | | Hardware mods to the RCX —Matt Lawrence
|
| | | | Ok, I'm interested in doing some hardware mods to a few RCX bricks to get better communication. So here are a couple of questions: 1. Has anyone published an actual schematic of the 1.0 RCX? 2. Has anyone already designed a USB interface to the RCX? (...) (22 years ago, 27-Oct-02, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Hardware mods to the RCX —Stef Mientki
|
| | | | (...) FDTI chips are very easy to use, look at (2 URLs) I'm thinking about using the power from the (...) Maybe there some usefull links at the next page under the block "Mindstorms Internals" (URL) the IR components by a serial connection won't be (...) (22 years ago, 27-Oct-02, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Hardware mods to the RCX —Matt Lawrence
|
| | | | (...) Actually, I was hoping to leave the existing IR circutry in place and just switch it out when a cable is connected. That should give me backwards compatability. As far as the firmware, I expect to be writing my own code in Forth, so shifting (...) (22 years ago, 27-Oct-02, to lugnet.robotics)
|
| | | | |
