Subject:
|
Quick reference for NQC?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 10 Oct 2002 01:11:30 GMT
|
Viewed:
|
723 times
|
| |
|
|
Where would I find a simple reference for getting started with NQC? I'm
looking for something that lists what software/firmware you need to get NQC
code into the RCX and walks you through getting a program running.
Thanks!
--
Tony Hafner
www.hafhead.com
|
|
Message has 4 Replies:
 | | Re: Quick reference for NQC?
|
| This may not help, but try BricX. I believe it comes with NQC built in, along with a nice little GUI. The firmware is the same as what came with your lego software. I don't know about you, but I was pretty much able to learn how by looking at the (...) (22 years ago, 10-Oct-02, to lugnet.robotics)
| | | Re: Quick reference for NQC?
|
| (...) The manual that comes with NQC is well written and quite concise - it's hard to imagine something smaller that would still tell you all you need to know. I recommend that you RTFM. ---...--- Steve Baker ---...--- Mail : <sjbaker1@airmail.net> (...) (22 years ago, 10-Oct-02, to lugnet.robotics)
| | | Re: Quick reference for NQC?
|
| (...) Tony, I'm sure eventually once you get past the installation and compiling and downloading and all that stuff a reference sheet with NQC commands will come in handy. I've found a few of them for you: (URL) it helps you somewhat. :-) ~Mike (...) (22 years ago, 10-Oct-02, to lugnet.robotics)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
