To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 19161
19160  |  19162
Subject: 
Re: Adapting mini-rc reciever to an RCX sensor
Newsgroups: 
lugnet.robotics
Date: 
Wed, 9 Oct 2002 23:47:35 GMT
Original-From: 
Steve Baker <sjbaker1@{AvoidSpam}airmail.net>
Reply-To: 
sjbaker1@airmail.net%nomorespam%
Viewed: 
917 times
  
chcc@xaosnet.com wrote:
I've noticed you can now buy little RC cars and was wondering if anyone
has thought about converting one into an RC unit for the RCX. You could
take the steering and motor control outputs and covert it into a seven
state analog output for the RCX sensor to read in. You might even be able
to power the reciever with the sensor power output used to power the light
sensor. At $20USD for the little mini-rc car it would be a cheap way to
get an RC transmitter/receiver for the RCX. Any thoughts?

Most toy and model R/C interfaces use pulse-width modulation.  You could
simply send that data stream into the RCX which would take a fair amount
of software decoding (I doubt you could do it with the Lego Firmware - you'd
C and LegOS or something).

If you could pull it off, you'd get up to 8 analog inputs with high end radio
gear...fewer with cheaper equipment...using just a single RCX sensor port and
without having to use tricky analog communications strategies.  That should
also be easier to implement hardwarily too.

----------------------------- Steve Baker -------------------------------
Mail : <sjbaker1@airmail.net>   WorkMail: <sjbaker@link.com>
URLs : http://www.sjbaker.org
        http://plib.sf.net http://tuxaqfh.sf.net http://tuxkart.sf.net
        http://prettypoly.sf.net http://freeglut.sf.net
        http://toobular.sf.net   http://lodestone.sf.net



Message is in Reply To:
  Adapting mini-rc reciever to an RCX sensor
 
I've noticed you can now buy little RC cars and was wondering if anyone has thought about converting one into an RC unit for the RCX. You could take the steering and motor control outputs and covert it into a seven state analog output for the RCX (...) (22 years ago, 9-Oct-02, to lugnet.robotics)

4 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR