 | | Re: Semantic Shuttle Cost
|
|
(...) Try rec.arts.sf.written....rt-jordan. Any thread with more than 5 messgaes is 70-80% likely to be offtopic. And the regulars all like to indulge in a bit of semanticizing regularly, not to mention recklessly thrown open robes, and gerbils, and (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: NQC software for Mac? (Robolab back ordered)
|
|
(...) Don't be so negative. All you need to do is hack the emujlator so that continuously reports those two pins shorted. Jasper (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | RE: Funny Picture (link corrected)
|
|
Hi, My Email thingy truncates the *tml* from the rest of the address, also. All I do is click on it, it returns an error, then I list pages visited, and cursor over to the end, and type in *tml* and I see the picture fine. --David M.-- ===...=== (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: RCX port information
|
|
(...) Nobody tried so far. The above is merely speculation - that's why I said "candidates". Should the pins turn out to be unused, legOS will support 6 A/D channels with minor changes. I have some software to work on right now, and I have a student (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: space shuttle technic set cost?
|
|
(...) This is an alright set, but I don't think that its of interest to most robotics types. It has very few gears and lots of beams (so if you need beams its the one to get). The gears are all crown gears. alex (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | NQC Commands
|
|
Where can I find a list of commands to use with the RCX Command Center? Bob (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: NQC Commands
|
|
(...) In the subject of your mail you wrote NQC, but you referred to the RCX Command Center in the question. Beware, those are two completely different products! Laurentino Martins [lau@mail.telepac.pt] [(URL) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: NQC Commands
|
|
Everything you ever wanted to know about NQC is available at Dave Baum's site: (URL) take a look at nqcc.doc or nqcc.rtf in your RCX-CC package. Enjoy ... NQCC and RCX-CC make a *great* team! - - - Nick - - - (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Can't read LegOS logbook (browser errors)
|
|
I can see the entry page, but when I try to look at the logbook, I get an error which says this program (IE4.01 for Mac) can't understand the protocol being used. This happens after the advertising pop-up has appeared. I was able to see the old (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Laser pointing devices could cause damage
|
|
Hi I was wondering if these little pocket laser pointing devices can damage the RCX infrared sensor and also the light sensor? Anyone know about this. The laser would be fun to use as a trigger device for the RCX, of course if it only works once.... (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: New ROBOLAB pages....
|
|
The IR tower can be used on a MAC using ROBOLAB and a MAC cable for the tower. Pitsco ((URL) sell the MAC cable (bundled with the tower) (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | ROBOLAB in Europe
|
|
Hi all Is somebody outthere aware of a possibility to buy ROBOLAB in Europe (Switzerland to be more specific). I am proud owner of the Mindstorm Robotic package but would like to buy the ROBOLAB software for my Macs too. Thanks for any hint along (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | RE: Batteries?
|
|
(...) How about using rechargeable alkaline batteries? (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | RE: space shuttle technic set cost?
|
|
Yes, 8277 is mostly good for getting lots of long beams in yellow and grey. However, it also contains a good number of "push-pin pegs". These are like the normal black 3-beam friction connector pegs, but with a bushing attached on one end. They come (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Laser pointing devices could cause damage
|
|
(...) Well, I didn't even take that into consideration when I tried it. It worked, and I haven't noticed any change in the performance of my sensor. I'm not exactly sure how the sensor works, but I'm pretty sure it's a CdS photoresistor, so the (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Robot Battery Level
|
|
I'd like to program my robot to beep for attention when the batteries start to wear down, however it appears that only the tower can query the battery voltage. I'd rather not have my computer query the robot and send the battery level back to the (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: flexible tubbing
|
|
(...) I think the Lego tubing is PVC, rather than rubber. Silicone rubber tubing might be more flexible, though I think it will also be heavier. It's most conveniently found in small diameters at model shops, sold as fuel tubing for model aircraft. (...) (28 years ago, 16-Dec-98, to lugnet.robotics)
|
| |
 | | How do I get off this thing??? 8-)
|
|
How do I get out of this list????? /\/\ark Interactive Media Developer rgbStudio, Inc www.rgbstudio.com (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: How do I get off this thing??? 8-)
|
|
Mark Streed wrote in message (...) Iif you send an blank email to the address indicated you will be unsubscribed from the list. lego-robotics-unsubs...crynwr.com instructions were found in the third paragraph of this page: (URL) write me if you are (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Now one with my address
|
|
(...) ldsmith@pfc.forestry.ca (28 years ago, 17-Dec-98, to lugnet.robotics)
|