Subject:
|
Re: NQC software for Mac? (Robolab back ordered)
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 17 Dec 1998 03:45:46 GMT
|
Original-From:
|
Garry Paine <garry4@/spamless/earthlink.net>
|
Viewed:
|
3799 times
|
| |
|
|
Chris,
If it is just having RTS=CTS, a software solution may be possible. E.g.:
patch the SPIRIT.OCX so that it always returns RTS=CTS, patch the Mindstorm
so that it doesn't care if the tower is connected, or patch windows or DOS
so that RTS=CTS.
Garry
> On Dec. 16 98, 15:10 PST, "Eric Hodges" <eric.hodges@platinum.com>
> wrote:
>
> > It's been a long time since I worked with serial hardware, but
> > isn't there an alternative pair of pins to RTS/CTS? DTR/DTS or
> > something like that? If the Mac sets the other pins you might be
> > able to short them to the RTS/CTS pins. I know I've done this on
> > special cables built to connect the 2 types of equipment.
>
> DTR/CD aren't alternatives, they serve an entirely different purpose.
>
> The PC software toggles the CTS signal, which the tower shorts to
> RTS, so that it can tell if the tower is connected.
>
> Since the Mac serial port doesn't have those pins, there's no way
> to use the PC software under emulation.
>
> ---
> Chris Osborn FozzTexx Enterprises
> 707 226 7629 - Voice 2136 Coronado Ave.
> 707 253 3063 - Fax Napa, CA 94559
> <fozztexx@fozztexx.com> <http://www.fozztexx.com/>
|
|
Message is in Reply To:
 | | RE: NQC software for Mac? (Robolab back ordered)
|
| It's been a long time since I worked with serial hardware, but isn't there an alternative pair of pins to RTS/CTS? DTR/DTS or something like that? If the Mac sets the other pins you might be able to short them to the RTS/CTS pins. I know I've done (...) (28 years ago, 16-Dec-98, to lugnet.robotics)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
