 | | Re: Question for you Technic pros
|
|
Hi: (...) The cross axle w/ eyes (Lego's name, not mine!) was in only 1 technic set, the small front end loader 8235 (1995). It differs from the two tie rods in that the tie rods can accept a ball joint but the axle w/ eyes cannot. The cross axle (...) (28 years ago, 19-Dec-98, to lugnet.robotics)
|
| |
 | | Re: flexible tubbing
|
|
(...) Hello... Your logging machine sounds like a great model. I hope you're able to show a bunch of detailed pictures in the future. <ICS> (28 years ago, 18-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Question for you Technic pros
|
|
Linc Smith wrote in message ... (...) that (...) I'm not quite sure to which part you are refering at the above site, unless you are talking about the "rack w/ tie rods" which is still quite different from the cross axle w/ eyes #16. But now that I (...) (28 years ago, 18-Dec-98, to lugnet.robotics)
|
| |
 | | RE: urgent request help !!!!
|
|
-----Original Message----- From: phillip chia [mailto:philchia@sin...et.com.sg] Sent: Friday, December 18, 1998 7:04 AM To: handybd Cc: Mr Peter Lim Subject: urgent request help !!!! Hi Fred and others, I very desperate to debug the problem that (...) (28 years ago, 18-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Question for you Technic pros
|
|
John, if I am thinking of the same piece (cross axle w/ eyes #16, 1995) that can be found at (URL) I am aware of at least two very similar piece that is 6 studs (fairly sure) long. They are meant to accept a ball to form a ball-joint. Check out (URL) (28 years ago, 18-Dec-98, to lugnet.robotics)
|
| |
 | | Vertical Mill
|
|
I have posted pictures and a QuickTime movie of my new vertical mill at (URL) Bob Fay rfay@we.mediaone.net (28 years ago, 18-Dec-98, to lugnet.robotics)
|
| |
 | | RE: All-around-the-robot bump detection
|
|
Or you could begin to take a series of actions. If an action results in another hit on the bumper (or a continuous hit) then you abandon that action. So the robot tries everything until something works. That's just like evolution. :) -----Original (...) (28 years ago, 18-Dec-98, to lugnet.robotics)
|
| |
 | | Question for you Technic pros
|
|
Does the "Cross axle with holes" exist in any lengths other than 16? If so, in what lengths does it exist, and if possible what are the part numbers of the other lengths? -John Van (28 years ago, 18-Dec-98, to lugnet.robotics)
|
| |
 | | Re: All-around-the-robot bump detection
|
|
(...) What if something hits the robot? (28 years ago, 18-Dec-98, to lugnet.robotics)
|
| |
 | | dc motor output control
|
|
hi everyone, i need some help on controling the output voltage of the dc motor ports. the output voltage is 9.6V and i like to know if there is any way to clamp down the voltage to 5V or lesser. i try using a enternal resistor but the output signal (...) (28 years ago, 18-Dec-98, to lugnet.robotics.handyboard)
|