Subject:
|
Question for you Technic pros
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 18 Dec 1998 22:06:34 GMT
|
Viewed:
|
1267 times
|
| |
|
|
Does the "Cross axle with holes" exist in any lengths other than 16? If so,
in what lengths does it exist, and if possible what are the part numbers of
the other lengths?
-John Van
|
|
Message has 2 Replies:
 | | Re: Question for you Technic pros
|
| John, if I am thinking of the same piece (cross axle w/ eyes #16, 1995) that can be found at (URL) I am aware of at least two very similar piece that is 6 studs (fairly sure) long. They are meant to accept a ball to form a ball-joint. Check out (URL) (26 years ago, 18-Dec-98, to lugnet.robotics)
| | | Re: Question for you Technic pros
|
| (...) A bit off the topic, but there does exist a similar piece that has a length of 11 studs or so. There's one in blue in the 8462 Tow Truck (URL) has an I cross section, and is slightly more narrow than a usual beam. The 4216 Basic set also has (...) (26 years ago, 23-Dec-98, to lugnet.robotics)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
