 | | Re: flexible tubbing
|
|
(...) I think the Lego tubing is PVC, rather than rubber. Silicone rubber tubing might be more flexible, though I think it will also be heavier. It's most conveniently found in small diameters at model shops, sold as fuel tubing for model aircraft. (...) (28 years ago, 16-Dec-98, to lugnet.robotics)
|
| |
 | | Robot Battery Level
|
|
I'd like to program my robot to beep for attention when the batteries start to wear down, however it appears that only the tower can query the battery voltage. I'd rather not have my computer query the robot and send the battery level back to the (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Laser pointing devices could cause damage
|
|
(...) Well, I didn't even take that into consideration when I tried it. It worked, and I haven't noticed any change in the performance of my sensor. I'm not exactly sure how the sensor works, but I'm pretty sure it's a CdS photoresistor, so the (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | RE: space shuttle technic set cost?
|
|
Yes, 8277 is mostly good for getting lots of long beams in yellow and grey. However, it also contains a good number of "push-pin pegs". These are like the normal black 3-beam friction connector pegs, but with a bushing attached on one end. They come (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: HD LCD problems
|
|
(...) On a lark, I'll suggest that perhaps U6 is damaged. If you have another 74HC138 around, try swapping it for the one on your HB. I had a "similar" problem (although not identical) and was able to diagnose the 74HC138 as the problem. I too was (...) (28 years ago, 17-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | RE: Batteries?
|
|
(...) How about using rechargeable alkaline batteries? (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | ROBOLAB in Europe
|
|
Hi all Is somebody outthere aware of a possibility to buy ROBOLAB in Europe (Switzerland to be more specific). I am proud owner of the Mindstorm Robotic package but would like to buy the ROBOLAB software for my Macs too. Thanks for any hint along (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: New ROBOLAB pages....
|
|
The IR tower can be used on a MAC using ROBOLAB and a MAC cable for the tower. Pitsco ((URL) sell the MAC cable (bundled with the tower) (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Laser pointing devices could cause damage
|
|
Hi I was wondering if these little pocket laser pointing devices can damage the RCX infrared sensor and also the light sensor? Anyone know about this. The laser would be fun to use as a trigger device for the RCX, of course if it only works once.... (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Can't read LegOS logbook (browser errors)
|
|
I can see the entry page, but when I try to look at the logbook, I get an error which says this program (IE4.01 for Mac) can't understand the protocol being used. This happens after the advertising pop-up has appeared. I was able to see the old (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|