To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6411 (-10)
  Re: light sensor
 
(...) Even if you point it directly at a very bright light? (28 years ago, 15-Dec-98, to lugnet.robotics)
 
  Re: Mindstorm/CyberMaster Swap
 
(...) You can do stall detection this way? How can this be done using NQC, say? I've brought up this issue in this discussion group earlier, but noone knew how to do stall detection, or so it seemed to me. Fredrik (28 years ago, 15-Dec-98, to lugnet.robotics)
 
  Re: Mapping
 
(...) Watch the critical angle for the sonar too. If the sonar doesn't hit almost straight on, some of the energy will be reflected off at an angle, and may provide false longer distances. Smooth surfaces will have a lower critical angle then coarse (...) (28 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
 
  RE: Mindstorm/CyberMaster Swap
 
The "more advanced" I was referring to are the pistons, and gears, and motors. I am going to London in a few days, can it be picked up there? Say at like Harrods or the like? Bill Barfoot I.T. Analyst (...) (28 years ago, 15-Dec-98, to lugnet.robotics)
 
  Lego Mindstorms in stock
 
Does anybody know an online shop where I can get a Lego Mindstroms kit before christmas? Thanks for your help. Heinz ___...___ More than just email--Get your FREE Netscape WebMail account today at (URL) (28 years ago, 15-Dec-98, to lugnet.robotics)
 
  Re: Mapping
 
I've just started experimenting with mapping and these are my thoughts on it. Drop the robot anywhere in its environment. The robot has a sonar hooked to a servo so the sensor can be scanned horizontally. As the sensor sweeps from left to right, (...) (28 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
 
  Re: light sensor
 
(...) 6.6 V DC is kinda low for new batteries. It should read 7 to 8 VDC with a normal multi-meter. The light sensor should easily read 100 when a flashlight is pointed into it, but my sensor doesn't read much below 20 in the dark.Somewhere in the (...) (28 years ago, 15-Dec-98, to lugnet.robotics)
 
  Re: SRAM and orLCD problem
 
eric, i don't have a definitive answer, but here are two things: 1. You *NEED* the reset chip, whether it's a DS1233 or the MC34064HC, I don't care, but you must have a device that asserts reset (pulls the line low) when the system voltage falls (...) (28 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
 
  Re: RCX Command Center Version 1.0
 
I apologize. You are right. The software has been tested on Windows 95 and NT 4.0 and should also run on Windows 98. (I will add the info on my Web site.) Mark Overmars (...) (28 years ago, 15-Dec-98, to lugnet.robotics)
 
  Re: RCX Command Center Version 1.0
 
(...) As far as I can see, there's no way to find out what kind of platforms it runs on until you actually download the software. Fredrik (28 years ago, 15-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR