 | | Subtasks quitting before completing
|
|
I saw some posts during the last three days about subtasks quitting before completing. I never saw a solution, so I will re-ask the question. If my robot triggers a touch sensor and before it completes all of the commands in that group of commands (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Spirit.ocx manual
|
|
Marshall Williams wrote in message <01BE0BB7.9F1AB180.M...tt.net>... (...) You may want to check out: (URL) Brok Visit LEGO ON MY MIND: (URL) section: (URL) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Subtasks quitting before completing
|
|
(...) The confusion is because only instantiation of each stack can be active at a time. If you start a stack that is already running, that stack stops, then restarts. The rule for conflicting signals is that the last one set has precedence. So if (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Subtasks quitting before completing
|
|
(...) This weekend I built a 4x4 rover with two front bumper sensors. I was faced with the problem of both sensors triggering at the same time. My fix was to set the counter to 1 and add a stack controller to check the counter before turning the (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Firmware: IR transmission demystified
|
|
IR transmission was pretty tough to get at. Carrier frequency was the final key - there are no crystals to create the IR carrier, so the processor has to provide it. It turns out that 8-bit t1 output is used for just that purpose. Guess I'll have to (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Solar-powered RCX?
|
|
I think the RCX will use which ever supply voltage is greater. I havn't tested this, but I'll bet that when you plug the AC adapter into the RCX when the AC adapter is not even plugged into the wall the RCX will still work. This means there isn't a (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Solar-powered RCX?
|
|
(...) I'm almost positive that the RCX uses whichever is greater, within a diode drop somewhere. But even still, I imagine that there is some leakage current from the batteries. Or maybe I was imagining that, and my batteries did not really drain. (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Cybermaster Spirit.OCX and Visual Basic
|
|
In message <3.0.5.32.1998100914...elia.com>, Ole Christian Gulbrandsen <olechr.gulbrandsen@....telia.no> writes (...) Thanks. :-) I was referring to the possibility that the interpreted source code may be too slow to communicate effectively with the (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | cybermaster case
|
|
I have a cardboard case with plastic handles. Apparently it should be a nice aluminium one. Does anybody know why this is? Will it be a collectors item? :-) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Multiple Cybermasters
|
|
This is an important consideration as over here in the UK, we have a robot wars program currently showing on BBC TV where contestants control their creations in an arena via radio control. Note that this is not the same as two autonomous computers (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|