To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *44334 (-10)
  Re: MOC: Working solar powered rover and geiger counter
 
(...) Well I'm certainly impressed that you were able to get a (not insignificant) saving through software alone. (I use NQC and the lego firmware, so I doubt I could implement this - I think I'll wait for NXT before learning a new system :-). OTOH, (...) (21 years ago, 21-Feb-06, to lugnet.robotics)
 
  Re: How would we (the rest of us) communicate ideas to the MDP?
 
(...) I don't think even the people on the MDP will have much input along the lines of what you're thinking - with only a few months before release, I imagine the role of the MDP people will be that of beta-testers - bang on it and report software (...) (21 years ago, 21-Feb-06, to lugnet.robotics)
 
  How would we (the rest of us) communicate ideas to the MDP?
 
I'm going on the assumption that I am not going to be part of the Mindstorms Developers Panel. That's OK with me, as I know that there are definitely 100 people in the World who are MUCH more qualified and/or can spend much more time on it than I (...) (21 years ago, 20-Feb-06, to lugnet.robotics)
 
  Re: MOC: Working solar powered rover and geiger counter
 
Measurements: normal RCX (no sensors, no motors, IR-off, no sound): 33mA in snooze mode : 25mA Not famous, but with solar panels to have or not have 8mA is the question. :) (21 years ago, 20-Feb-06, to lugnet.robotics)
 
  Re: MOC: Working solar powered rover and geiger counter
 
(...) Hey, your RCX power-on electronics challenged me to try to wake up the RCX by software. This is quite difficult, because if powered down, the RCX not only shuts down all its peripherical devices, but also sends the H8 micro-controller to (...) (21 years ago, 20-Feb-06, to lugnet.robotics)
 
  Re: Motor Analysis
 
(...) I wouldn't go too far in this exercise of matching motors. Even if you were to able to get two perfectly matched motors on your robot, chances are it will still not go perfectly straight due to many other factors. Notably, if you have a (...) (21 years ago, 20-Feb-06, to lugnet.robotics)
 
  Re: Motor Analysis
 
(...) I use the LEGO speedometer (5206) to find matching motors for my robotics classes. Works reasonably well. Fast and easy. Regards, Jutta Rossmaier (21 years ago, 19-Feb-06, to lugnet.robotics)
 
  Re: looking to trade technic beams for black technic beams
 
(...) i have completed 1 trade and have the following left. if your looking for white or gray, it's your lucky day. 1x16's *54 lt. gray *7 white 1x12's *12 white 1x10's *8 white 1x8's *13 white 1x6's *20 green *41 lt. gray *16 white *23 red 1x4's (...) (21 years ago, 19-Feb-06, to lugnet.market.buy-sell-trade, lugnet.technic, lugnet.robotics)
 
  Re: Motor Analysis
 
(...) I'm not sure how to grab data from the RCX with the 'standard' tools. However... as much as I am for wild statistical analysis with a computer, the easiest solution might be to just use one of those cool LEGO differential axels. Put one motor (...) (21 years ago, 19-Feb-06, to lugnet.robotics)
 
  Re: Motor Analysis
 
(...) Did you check here; (URL) has done a lot of work which might be of use. JB (21 years ago, 19-Feb-06, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR