 | | Re: RCxcc
|
|
use bircxcc (22 years ago, 14-Dec-03, to lugnet.robotics.scout)
|
| |
| | Re: Bump switches and "aggression"
|
|
there's probably a way to use a light sensor to sense four different colored bricks. one for each direction. = sensor red ylw blue wht / ---\ /---- different heights of 'wedges' would lift a column, as a bumper is either slid in, or the bumper (...) (22 years ago, 16-Dec-03, to lugnet.robotics)
|
| |
| | Re: Bump switches and "aggression"
|
|
You could attach 2 touch sensors to each port and take a look at the raw values when different combinations of the sensors are pressed. ----- Original Message ----- From: "Øyvind Steinnes" <phoenix@online.no> To: <lego-robotics@crynwr.com> Sent: (...) (22 years ago, 16-Dec-03, to lugnet.robotics)
|
| |
| | Re: Bump switches and "aggression"
|
|
By the way, there are 5 states, all switches off, and each of the 4 switches. (That does not count the combinations if more than one switch were triggered at the same time). Thus a binary solution would take three inputs, just one less than the (...) (22 years ago, 16-Dec-03, to lugnet.robotics)
|
| |
| | Re: Alternate Energy Sources
|
|
"Nikhil Sarma" <lego-robotics@crynwr.com> wrote in message news:1071524909.3fde...ojo.com... (...) prospect of (...) I have done some experimenting with the Lego Solar panel with the Lego capacitor. Each solar panel with the capacitor will provide (...) (22 years ago, 16-Dec-03, to lugnet.robotics)
|
| |
| | Re: Bump switches and "aggression"
|
|
For a pure Lego solution, you could try rigging up something with a rotation sensor that would have the sensor point in the direction of the collision. Suppose the rotation sensor was mounted with it's input shaft pointing up vertically - with a (...) (22 years ago, 16-Dec-03, to lugnet.robotics)
|
| |
| | Re: Bump switches and "aggression"
|
|
There was discussion of one company that made switches with analog values that could be mixed, but they were apparently either expensive or hard to find (at least there was some difficulty). But simple resistor network, say a load resistor to ground (...) (22 years ago, 16-Dec-03, to lugnet.robotics)
|
| |
| | Re: Alternate Energy Sources
|
|
(...) It would take a truly immense number of solar panels to drive an RCX with a couple of motors. The Lego Solar Panel (you can get it from Pittsco Dacta from their educational stuff) just barely drives one motor...very slowly - and then only in (...) (22 years ago, 15-Dec-03, to lugnet.robotics)
|
| |
| | Re: Bump switches and "aggression"
|
|
"Rob Limbaugh" <lego-robotics@crynwr.com> wrote in message news:004201c3c2be$0a...markera... (...) can (...) How can I attach lets say 4 switches so the make a binary code, (4switches should need only two ports). I want to have one switch on each (...) (22 years ago, 15-Dec-03, to lugnet.robotics)
|
| |
| | Alternate Energy Sources
|
|
I'm programming the RCX in the leJOS environment and don't like the prospect of downloading the firmware everytime I have to replace batteries. How good and reliable are the solar panels available for the RCX 2.0? Is anybody on the list using an (...) (22 years ago, 15-Dec-03, to lugnet.robotics)
|
