 | | Re: IR Tower not working when downloading firmware
|
|
(...) Which physical pins are 2 and 3? I assume they would be the Tx and Rx pins, but I don't know where they are. Pretty cool - data going through a paperclip. (24 years ago, 11-Jan-03, to lugnet.robotics)
|
| |
 | | Re: IR Tower not working when downloading firmware
|
|
Andrew J. Huang wrote: > Wendy's problem is (...) The way to figure out which serial port on the back of the PC corresponds to which COM port is to use the world's cheapest piece of test equipment...the lowly paperclip. Bend your paperclip into a U (...) (24 years ago, 11-Jan-03, to lugnet.robotics)
|
| |
 | | Re: Not really LEGO...
|
|
"Michael Obenland" <obenland@t-online.de> wrote in message news:H8I2sr.9Lz@lugnet.com... (...) Iain (24 years ago, 11-Jan-03, to lugnet.robotics)
|
| |
 | | Re: Can't run software
|
|
(...) Thanks again Matthais, I have downloaded and installed this driver. But unfortunately there is no change. Bill Lane (24 years ago, 11-Jan-03, to lugnet.robotics.spybotics)
|
| |
 | | Re: IR Tower not working when downloading firmware
|
|
No! Unless you need two RCXs - and that's a different question ;) Donwloading the firmware seems to be the most "stressful" exercise of the tower/RCX link. The download functions offered include a high speed mode and normal mode. The tower and RCX (...) (24 years ago, 10-Jan-03, to lugnet.robotics)
|
| |
 | | Re: Spybotics Internals
|
|
(...) Sure...that would be a good reference for the page as well. I'll try and do that next week. Steven (24 years ago, 10-Jan-03, to lugnet.robotics.spybotics)
|
| |
 | | RE: IR Tower not working when downloading firmware
|
|
Andy, It is not COM port problem. I have used the same PC and the same configuration to successfully download to RCX the night before I took all the batteries out of the RCX. After 24 hours without battery, the RCX lost its firmware. It fails to (...) (24 years ago, 10-Jan-03, to lugnet.robotics)
|
| |
 | | RE: IR Tower not working when downloading firmware
|
|
Wendy, Dick, I'm fighting the same issue on a RIS 1.5. I haven't resolved the problem yet but let me share what I've found. Character echo means only that you've connected to the IR tower. Using hyperterminal, I get perfect echoes, but I get them (...) (24 years ago, 10-Jan-03, to lugnet.robotics)
|
| |
 | | RE: IR Tower not working when downloading firmware
|
|
Thanks for the response. I just got back from a trip and see this message. I did perform the test you mentioned in the email. I used the hyper terminal program to determine that the problem is lack of echoed characters. What is your advice on fixing (...) (24 years ago, 10-Jan-03, to lugnet.robotics)
|
| |
 | | Re: Big synchro drives: vacuum cleaner, lawn mower
|
|
Thanks everyone for the comments. Iain: I know the offset solutions. Two wheeled seemed to be a lot more stable back then. Rob: Good stuff on your page. Do you thing BrickOS will read the rotation sensor faster? That might solve everything. BTW, I (...) (24 years ago, 10-Jan-03, to lugnet.robotics)
|