 | | RE: Programming multiple controllers
|
|
(...) OK, I'll bite, how does the Spybot get into this state? We've already discussed how to set up a secure link - how do we set up a non-secure link? Cheers, Ralph (24 years ago, 10-Aug-02, to lugnet.robotics.spybotics)
|
| |
 | | Re: Programming multiple controllers
|
|
(...) got (...) configuration? Bot one must be on Accept commands from ALL channels Mode. Dean (24 years ago, 10-Aug-02, to lugnet.robotics.spybotics)
|
| |
 | | Win98 install help
|
|
Hi there. Please can someone help me. I've been following the instructions at: (URL) word for word and then I got to the bit where it says: "Last setup I've tried let you choose which modules you need to download and setup. Here is a minimal list (...) (24 years ago, 10-Aug-02, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: measuring motor voltage on sensor input
|
|
Quoting Paul Andrews <paul@jools.net>: (...) How about a simple resistive divider across the motor output, say two 1 Kohm resistors, with the motor on the top of the two and the sensor input on the midpoint, so it sees the battery divided by two? (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | RE: Brainstorms
|
|
(...) <just an opinion> The 2400 baud rate was probably chosen as a compromise between speed and what could reasonably be done on the teeny leetle PIC processor that drive the bricks. In practice, with the dedicated protocol that Wayne describes, (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | Re: Brainstorms
|
|
(...) the interconnect protocol is run so slowly. Why only 2400 baud? Anything where you have an actual copper wire connection could run orders of magnitude faster. Heck even iRDA goes faster over infraRed. ---...--- Steve Baker ---...--- Mail : (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | RE: Brainstorms
|
|
Wayne, In the spec you indicate that each brick gets its own 128 bit random number. This is like a serial number that is initially use to uniquely identify each brick with a shorter BrickID. This is a common technique in fire alarm systems where (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | RE: Brainstorms
|
|
Wayne wrote (in his first post no less!) (...) <snip> (...) <snip> This is more like it. I've snipped out the juicy bits on the serial comms channel and modular power connector. The comms channel sounds a bit slow, but then again the fire alarm (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | Re: Brainstorms
|
|
All: I think the project that I am working, called RoboBricks, on is quite relevant to this topic. Since this is my first post to this group, I should introduce myself as a very active member of the Home Brew Robitics Club based out of San Jose, (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | Re: LEGO Purism
|
|
There are good, rational reasons for most of these decisions: (...) That makes good sense - because once a piece has been modified, you can't use it for it's intended purpose again. (...) That also makes sense - because it's purely decorative - and (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|