To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *28679 (-10)
  Need help with bumpers connected to the HB
 
Hi, I’ve got a problem in getting started with the Handy Board. I’d like to connect a bumper detection circuit to the analog0 of my HB. But when I connect the bumper circuit to my HB , the HB turns itself off. Can anybody help me? Any help would be (...) (25 years ago, 23-May-01, to lugnet.robotics.handyboard)
 
  Re: High Strength Powered Steerable pivot wheel
 
(...) I'm looking forward to the old sets, my last taste of LEGO was in the 70's, and all my bricks from that time are long gone. Mindstorms have re-kindled my love of lego, and technics feed the machine. If the two technics sets are re-released, it (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  LVI install problems
 
Given that I'm new to Java this is probably a silly question, but when I try to install LVI I get the error: C:\Steve\Lego\lejos\lvi>java install Exception in thread "main" java.lang.NoClassDefFoundError: install Java2 and LeJOS seem to be working (...) (25 years ago, 23-May-01, to lugnet.robotics.rcx.java)
 
  Re: High Strength Powered Steerable pivot wheel
 
(...) All the replies were apparently trying to help you to create a steerable wheel with no motors in the assembly. Did you consider rotating the entire motor/wheel assembly? The advantage is that you don't need a drive to go through the rotating (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: 27 IR signals by using the LEGO Remote Control
 
(...) 11 (...) Alternatively, input 1 could be start/stop frame and input 2 and 3 could be 0 and 1 allowing you to enter any binary number (low bit first). This is workable for us nerd couch potatoes who think in binary and are really fast with the (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: 27 IR signals by using the LEGO Remote Control
 
This is a good idea. You could use the same principle to send 27 different values to a single RCX. I.e. your one and only RCX could act as its own MUX. Here's an encoding scheme that gives you 1 one-key combination, 3 two-key combinations, and 6 (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  27 IR signals by using the LEGO Remote Control
 
I've found a way to provide 27 IR signals from the LEGO remote control. See my site for an explanation: (URL) essence you need 2 RCX, 1 to act as a MUX. (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: Wishlist leJOS
 
(...) You could use the JavaComm package, look on the Java website for it. It should not be that hard to set up the port, write to it, and then get replies back. Look at the other Java projects mentioned on (URL) to see how communication is done. I (...) (25 years ago, 23-May-01, to lugnet.robotics.rcx.java)
 
  Re: Wishlist leJOS
 
I (another newbie) also would like to upload data from the RCX to a Windows PC. It looks like adding the data to a StringBuffer would be a good way to save it, but I have not much of a clue about how to write (1) the Java that runs on the PC to (...) (25 years ago, 23-May-01, to lugnet.robotics.rcx.java)
 
  Re: SHRIMP building
 
(...) Yes, something like this: | is a wheel pointed straight, \ and / are wheel turned left or right = is the body Going straight: | | |==| |==| | | Turning left: \ \ |==| |==| / / Turning right: / / |==| |==| \ \ Disclaimer: I haven't actually (...) (25 years ago, 23-May-01, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR