To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *22769 (-10)
  Re: LEGO-DCP Sensor Adapter
 
"David Hagan" <support@dcpmicro.com> wrote in message news:FyAwL1.E8J@lugnet.com... (...) There is a typo here. It should be (URL) . (26 years ago, 26-Jul-00, to lugnet.robotics)
 
  Re: Care and feeding of technic gear motors
 
Jammed motors out of the box is a common problem with the geared Technic motors.. That's not limited to Znap sets at all. A phone call to Lego customer service usually takes care of that problem quickly. Alternatively, you can say, what the heck, (...) (26 years ago, 26-Jul-00, to lugnet.robotics)
 
  Re: Technic & robotics-compatible LEGO ZNAP clearance at TRU
 
3591 does not contain any flex shafts. 3552 and 3571 should each contain two. Dennis (...) -- Dennis Williamson - Certified Y2K Complacent Bad News: The next millenium starts on a Monday. Good News: You get the day off. (remove .NO and SPAM. to (...) (26 years ago, 26-Jul-00, to lugnet.znap, lugnet.technic, lugnet.market.shopping, lugnet.robotics)
 
  Re: light sensor problem?
 
(...) I remember wondering what port 6 bit 3 did and so I think I tried setting it on and off and not noticing anything broken either way. Maybe I didn't test enough though. Somebody might want to try repeating the experiment. Some extra evidence is (...) (26 years ago, 26-Jul-00, to lugnet.robotics.rcx.legos)
 
  Care and feeding of technic gear motors
 
I have read a number of reports of people having problems with the technic gear motor. In particular, with them jamming. I have an embarrassingly large number of these motors and I had never observed a problem. However, I have noted that some of the (...) (26 years ago, 26-Jul-00, to lugnet.robotics)
 
  DDK and RDS on sale at Best Buy
 
I do not know if this sale is nation-wide or not, but in the Sunday 7/23 Best Buy sale flyer I saw that the store was discounting both RDS and DDK for this week (through 7/29). Yesterday evening I finally made it over there, and they did indeed have (...) (26 years ago, 26-Jul-00, to lugnet.robotics)
 
  Re: Technic & robotics-compatible LEGO ZNAP clearance at TRU
 
"Miles Gentry" <gentrym@gte.net> wrote in message news:Fy128y.Gz6@lugnet.com... (...) while (...) not (...) Good (...) Get (...) on (...) "clearance" (...) I didn't find a flexible drive shaft in this set. Can anyone confirm that it should be (...) (26 years ago, 26-Jul-00, to lugnet.znap, lugnet.technic, lugnet.market.shopping, lugnet.robotics)
 
  LEGO-DCP Sensor Adapter
 
I have been reading with interest the comments about our range of DCP sensors and their use with RCX. To help I thought we would post a few comments: Currently seven of our LogIT Microsense Sensors are supported by the LEGO-DCP adapter - sound, (...) (26 years ago, 26-Jul-00, to lugnet.robotics)
 
  Re: RF Connection To RCX
 
One way to accomplish this is to use wireless serial devices. These RF devices allows one to hook up ANY serial device wireless. I have seen some listed on ebay for about $100+. The setup is as follows: PC--> serial transmitter serial receiver-->IR (...) (26 years ago, 26-Jul-00, to lugnet.robotics.rcx)
 
  increased range of Infra Red
 
HI There Do You guys know how to increase the range of the infra red sensor to above 5 feet , if its an external circuit which I have to connect it does not matter , can some one send me the circuit so i can use the infra red sensor to sense a (...) (26 years ago, 25-Jul-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR