To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *13296 (+5)
  RE: Handy Board software
 
(...) They're both really decent 8bit micros. Similar IO capabilities, and I think the HC11 has better timers, but only 8 bit A/D. I've worked a LOT with the HC11 and it's really a good part. (...) Beleive it or not, there is a FORTH for the HC11 (...) (27 years ago, 9-Aug-99, to lugnet.robotics, lugnet.robotics.rcx.legos)
 
  Re: Using the Motor as a Tachometer
 
(...) SNIP (...) SNIP (...) Todd, The danger as I see it is not electrical but physical. If the sensor mode of the input port is "active" the port will provide power to the motor (sensor). Thus you could have 2 motors either working together or (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
 
  RE: Using the Motor as a Tachometer
 
(...) In fact, this is how the RCX motor controller internally sets the motor up for "brake" instead of "off"... Cheers, Ralph Hempel - P.Eng ---...--- Outside of a dog, a book is a man's best friend. Indside of a dog, it's too dark to read... (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
 
  Re: Power steering for 8448
 
(...) Good point! Well I'll have to change my model a bit then - the rotation sensor should not go onto the motor axle, but onto the axle driving the rack (stilled geared I guess). Hmm, what can I use this touch sensor for now?? An extra bumper (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
 
  Re: Using the Motor as a Tachometer
 
(...) Try to short circuit the motor used as tarcometer / generator, and you'll see. Also try preventing the second motor from spinning, and you'll experience the same thing. About efficiency: this is not what you are experiencing, but the motor (...) (27 years ago, 9-Aug-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR