Subject:
|
Re: Stock Yard Trials
|
Newsgroups:
|
lugnet.org.ca.vlc
|
Date:
|
Sun, 29 Apr 2001 22:42:33 GMT
|
Viewed:
|
1089 times
|
| |
|
|
James Powell wrote:
> > What about if we were to cut, GASP, some straight track? It's a long shot
> > and we'd have power problems but...
>
>
> No, really not a big problem...just use low melt (either 60-40, or a real low
> melt solder) to make electrical jumpers around the gaps. If you do it right,
> the gaps are fairly small anyway (hint, use a 2x8 plate as a cutting guide, and
> a jewelers saw to cut the plastic, along with a dremel to cut the metal)
>
> I think I have posted about how I make shortened track in .trains, perhaps a
> look will give you some ideas. It's not hard, but might be hard on the purist
> :)
>
> James
Yes, I know how to do it. I'm also very proficient with a iron. It's a possible
solution to the yard design hiccups.
Dean
--
Coin-Op's For Sale!: http://www.akasa.bc.ca/tfm/coin-op.html
Dean's Lego Workshop: http://www.akasa.bc.ca/tfm/lego_wr.html
Vancouver Lego Club: http://www.akasa.bc.ca/vlc
|
|
Message is in Reply To:
 | | Re: Stock Yard Trials
|
| (...) No, really not a big problem...just use low melt (either 60-40, or a real low melt solder) to make electrical jumpers around the gaps. If you do it right, the gaps are fairly small anyway (hint, use a 2x8 plate as a cutting guide, and a (...) (24 years ago, 29-Apr-01, to lugnet.org.ca.vlc)
|
13 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
