Subject:
|
Re: Turn table ideas
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Sun, 13 May 2001 14:00:30 GMT
|
Viewed:
|
453 times
|
| |
|
|
In lugnet.org.ca.rtltoronto, Martin Legault writes:
> In lugnet.org.ca.rtltoronto, Jeff Van Winden writes:
> > Hi Guys, • <snip>
> >
> > There are a few issues with this idea (although it is the one I prefer)
> >
> > 1) the current design, of the 2 track touch sensors are not great, the axles
> > move out of the 2 x 2 technic bricks due to vibration and can sometimes get
> > caught.
>
> Can you space the 2 1x2 brick apart and use a bushing between them to hold the
> axle in place?
>
> Martin
> <more snip>
Unfortunatly not, I only have a 5 stud area to work in, at 6 studs the
bricks would hit the drive motor.
Jeff
>
> > Any thoughts and Ideas would be greatly appreciated.
> >
> > Jeff
> > P.S. When I was at St' Jacobs last week they only had straight and curved
> > track, Loads of 4561's and not many other "unique" of hard to get items..
> >
> > There were a few blue 3033 Tubs there, but they were not 3033's they were
> > for the new Creator Line.
|
|
Message is in Reply To:
5 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
