Subject:
|
Re: Turn table ideas
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Sat, 12 May 2001 19:08:57 GMT
|
Viewed:
|
460 times
|
| |
|
|
In lugnet.org.ca.rtltoronto, Jeff Van Winden writes:
> Hi Guys, • <snip>
>
> There are a few issues with this idea (although it is the one I prefer)
>
> 1) the current design, of the 2 track touch sensors are not great, the axles
> move out of the 2 x 2 technic bricks due to vibration and can sometimes get
> caught.
Can you space the 2 1x2 brick apart and use a bushing between them to hold the
axle in place?
Martin
<more snip>
> Any thoughts and Ideas would be greatly appreciated.
>
> Jeff
> P.S. When I was at St' Jacobs last week they only had straight and curved
> track, Loads of 4561's and not many other "unique" of hard to get items..
>
> There were a few blue 3033 Tubs there, but they were not 3033's they were
> for the new Creator Line.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Turn table ideas
|
| Hi Guys, Well my round (rectangular actually) House is near completion. I need about 42 - 50 3 x 4 33 degree red slopes to finish it off (does any one have any that they want to sell? and I still have to do some interior detailing. The turntable is (...) (24 years ago, 12-May-01, to lugnet.org.ca.rtltoronto)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
