Subject:
|
Re: this place is DEAD..... lets kick it up a notch
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Mon, 3 Oct 2005 16:19:12 GMT
|
Viewed:
|
688 times
|
| |
|
|
David Koudys wrote:
> In lugnet.org.ca.rtltoronto, Chris Magno wrote:
>
> <snip>
>
> > i think DCC is a nice way to add many motors to a technics creation, and
> > only need once pass through wire.
> >
> >
> > Chris
>
>
> I'm going to give you an FYI, but if you DCC a 9v motor using the brick you're
> building, you get a diminished power output to the motor as oppsed to going
> straight 9 volts to the motor, or even using 'standard' RCX firmware. Now I
> don't know if it's just a configuration problem or something else, but I don't
> have the same power in a 9 volt connected via LDCC as I do when it's connected
> straight to a 9 volt source, or on full power off an RCX running the standard
> firmware
>
> Dave K
hummmm
what chip did you use?
this one is rated to 1 amp, and IIRC, the stall is higher. and IIRC,
(some more) the stall of the technic is LOWER.
we'll see.
maybe this is todays project.
Chris
|
|
Message has 1 Reply:
Message is in Reply To:
15 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
