Subject:
|
Re: robots, not trains
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Thu, 31 May 2001 21:20:43 GMT
|
Viewed:
|
755 times
|
| |
|
|
In lugnet.org.ca.rtltoronto, Chris Magno writes:
> > Can I start a robot by flipping a polarity
> > switch? Or do I have to press 'run' on the RCX?
>
>
> Any RCX needs the run switch pressed. either by pressing the green
> button on the unit itself, OR by sending it the IR command for run.
> (like the remote)
Except if you use LegOS. You can compile the program as a native srec, but you
need to put code in the startup to run your program when it's switched on, or
equivalent.
Regards
ROSCO
|
|
Message is in Reply To:
 | | Re: robots, not trains
|
| (...) Any RCX needs the run switch pressed. either by pressing the green button on the unit itself, OR by sending it the IR command for run. (like the remote) As Calum typed, and I just tried, have the second rcx run in a loop of nothing, UNTIL a (...) (23 years ago, 31-May-01, to lugnet.org.ca.rtltoronto)
|
7 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
