Subject:
|
Girders for Sale (was Re: Piece #2580 (outback airstrip))
|
Newsgroups:
|
lugnet.market.buy-sell-trade
|
Date:
|
Tue, 12 Dec 2000 17:23:02 GMT
|
Viewed:
|
1091 times
|
| |
|
|
I have a *very* limited supply of girders (2 black, 8 grey) that I
hadn't yet priced for inclusion on my Brickbay shop. But since there
seem to be plenty of interested buyers here and, last I heard, this
is still the place for sealed-bid type sales...
The following lists the minimum sale amount for each lot. Bid on
as many or few as you like. Shipping will be $3.20 in the U.S. for
a Priority Mail box or $1 for a padded envelope. I will ship
internationally if you can pay in USD. I will accept bids until
Wed. Dec. 13, 6:00 p.m. CST (about the time I'll get home from
work tomorrow.) Earliest equal bid received wins a tie.
B1: 2 black girders from set 6444 $6
G1: 2 grey girders from set 3313 $20
G2: 2 grey girders from set 3313 $20
G3: 2 grey girders from set 3313 $40
G4: 2 grey girders from set 3313 $40
The high start on the 2nd pair of grey lots is because I'd rather
keep the whole set than sell for less. If you're desperate for a
complete 3313 or two, feel free to make an offer that exceeds the
price for 4 girders. FYI, I'm after the trans-yellow 2x4 rounded-top
bricks and they're not exactly common either, so keep that in mind.
Doug
In lugnet.market.buy-sell-trade, Lindsay Frederick Braun writes:
> I know that I'd *easily* buy two or three hundred of these
> in black, but at the going rate of about $5 a pillar in
> black, about that in red, and $20 in light grey (ack!),
> I can't possibly afford them--even if they *were* available.
> Hopefully LD could put out lattice pillars for $1 each or
> less, probably not much less given that they're rather
> complex pieces on the order of a large door or window.
>
> Your best bet, Jonathan, might be to comb smaller stores
> for leftover copies of 6444 Outback Airstrip, which if you're
> lucky you can get for less than the $20 sticker price. The
> benefit of such a tactic is that if you're willing to part
> the sets out and run auctions, you might feasibly get the
> lattice girders for free (always the best price, I say).
>
> If that fails, you can always organise something with a person
> who hopes to buy a bajillion 2001 TIE fighters, and use the
> "new" triangular girder bit. I'd offer but, well, that's what
> I'm doing...:)
>
> best of luck,
>
> Lindsay
|
|
Message has 2 Replies:
Message is in Reply To:
10 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
