Subject:
|
Re: Part variation noted
|
Newsgroups:
|
lugnet.general
|
Date:
|
Tue, 30 Nov 1999 22:01:34 GMT
|
Viewed:
|
643 times
|
| |
|
|
I've seen 2 stud long technic rods that have the little "easier to pull"
notches in them and some without.
I also noticed that some of my 1x1 plates with the horizontal clip in them- on
some the clip is thinner than on others.
Chris
|
|
Message has 2 Replies:
 | | Brick variations (was Re: Part variation noted)
|
| As my journey from the Dark Ages continues, I have noticed some variations in the basic brick... o Old CA bricks have the plastic 'tear off' (aka the umbilical) on one of the short ends of the brick. Newer bricks (ABS) have the 'tear off' on one of (...) (25 years ago, 30-Nov-99, to lugnet.general)
| | | Re: Part variation noted
|
| I have 2 stud long Technic axles without the 'easy to pull' notches that were from the old Expert Builder series. When I came out of my dark ages, I got a few new sets, and saw the new 2 length axles with notches, I cheered. Most of my old ones have (...) (25 years ago, 1-Dec-99, to lugnet.general)
|
Message is in Reply To:
| | Re: Part variation noted
|
| I've noticed two types of Technic axle extenders. If you look through the cross axle hole in the extenders, you'll see that in the center there is a plastic flange which keeps an axle from going all the way through the extender (it only allows an (...) (25 years ago, 30-Nov-99, to lugnet.general)
|
14 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
