To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.gamingOpen lugnet.gaming in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Gaming / 600
599  |  601
Subject: 
Re: LEGO Foosball table
Newsgroups: 
lugnet.sports, lugnet.build, lugnet.gaming
Date: 
Thu, 5 Oct 2000 20:07:08 GMT
Viewed: 
850 times
  
In lugnet.football, Ralph Hempel writes:
What would it take to build a little Foosball table out of LEGO elements?
Let's say it used the Football/Soccer ball and maybe include some of the
minifigs.  For the bars and knobs, could Technic axles be used and extended
at key points where the players stand?  What's the longest Technic axle ever
given in a set, and are Technic axles rigid enough to stretch, say, 40 cm.
across a board?  Just some thoughts...

Well, The axles don't have to range freely across the board, so if you're
willing to GLUE them to axle connectors, you could make them any length
you want, but the range would be limited by the longest axle. (12 LU I think)

But how are you going to put them through the minifig torsos!!!!

I probably won't ever do this (too expensive and time-consuming) but I thought
it would be fun to think about.

Drilling holes in the torsos would probably work (eek! :-), if you've seen the
experiments that Paul Gyugyi did with his Hexatron figs (sorry, I don't have a
link handy, but basically it was Blacktron I figs with four arms).  I suppose
no matter what is used, it would have to be glued, 'cause people really hack
on Foosball I think.  :-)  And if you're using glue, you might as well drill,
unless there's a good way to avoid that.  Dunno -- good question.  :-)  I
guess you'd hafta also figure out a way for the minifig legs not to bend.

--Todd



Message has 1 Reply:
  Re: LEGO Foosball table
 
(...) extend the torsos with two of these: (URL) technics bricks. -Chuck (24 years ago, 5-Oct-00, to lugnet.sports, lugnet.build, lugnet.gaming)

Message is in Reply To:
  RE: LEGO Foosball table
 
(...) Well, The axles don't have to range freely across the board, so if you're willing to GLUE them to axle connectors, you could make them any length you want, but the range would be limited by the longest axle. (12 LU I think) But how are you (...) (24 years ago, 5-Oct-00, to lugnet.sports, lugnet.build, lugnet.gaming)

14 Messages in This Thread:







Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR