Subject:
|
Re: Problem finding standard parts in MLCAD
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Wed, 6 Jun 2001 21:37:57 GMT
|
Viewed:
|
2175 times
|
| |
|
|
In lugnet.cad.mlcad, Jake McKee writes:
> All,
>
> I am starting to actually _create_ MLCAD based models and I am having
> trouble locating some of the basic parts. 1x1 brick, 1x2 non-printed brick,
> 45 Slope 2x2 non-printed and 1x2 tile with one center stud are just a few I
> am having trouble locating. I have opened .dat files recently that I know
> contain those parts, I just can't seem to locate them within the MLCAD
> interface.
As I understand it, 1 x 1 brick is "3005.dat", but due to a bad alphanumeric
order, ALL of the lettered and numbered 1 x 1 bricks (3005-*.dat) come before
"3005.dat". As for the 1 x 2 brick, the normal (unpainted) one is "3004.dat".
The one with no post in the middle (usually used for lighting and other
transparent means) is "3065.dat".
If you have a Make List utility for LDraw, such as MKList.exe, run it again and
then start MLCAD after it finishes.
-- James J.
>
> Can anyone help me out?
>
> Thanks!
> Jake
You're welcome, Jake.
>
> ---
> Jake McKee
> AFOL
> LUGNET Member #211
|
|
Message is in Reply To:
 | | Problem finding standard parts in MLCAD
|
| All, I am starting to actually _create_ MLCAD based models and I am having trouble locating some of the basic parts. 1x1 brick, 1x2 non-printed brick, 45 Slope 2x2 non-printed and 1x2 tile with one center stud are just a few I am having trouble (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
15 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
