Subject:
|
Re: Problem finding standard parts in MLCAD
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Wed, 6 Jun 2001 03:33:11 GMT
|
Viewed:
|
2200 times
|
| |
|
|
did you hit regenerate list? mine was same way heh
--
And they said 'Computers will never be in general use'
"Jake McKee" <sink@countersinkdg.com> wrote in message
news:GEHnoC.Ftz@lugnet.com...
> All,
>
> I am starting to actually _create_ MLCAD based models and I am having
> trouble locating some of the basic parts. 1x1 brick, 1x2 non-printed • brick,
> 45 Slope 2x2 non-printed and 1x2 tile with one center stud are just a few • I
> am having trouble locating. I have opened .dat files recently that I know
> contain those parts, I just can't seem to locate them within the MLCAD
> interface.
>
> Can anyone help me out?
>
> Thanks!
> Jake
>
> ---
> Jake McKee
> AFOL
> LUGNET Member #211
|
|
Message has 2 Replies:
Message is in Reply To:
 | | Problem finding standard parts in MLCAD
|
| All, I am starting to actually _create_ MLCAD based models and I am having trouble locating some of the basic parts. 1x1 brick, 1x2 non-printed brick, 45 Slope 2x2 non-printed and 1x2 tile with one center stud are just a few I am having trouble (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
15 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
