| | custom 73590a hose flexible
|
|
I have been trying to make custom bent flexible hose part 73590a using parts 750 (hose flexible end 1 x 1 x2/3 with tabs) 754 (hose flexible segment link section)755 hose flexible segment end section)and 756 hose flexible segment centre section) (...) (23 years ago, 29-Oct-01, to lugnet.cad.mlcad)
|
|
| | Re: View matrix used for default 3D view expressed in LDLite terms
|
|
"Steve Bliss" <steve.bliss@home.com> wrote in message news:GLnxLM.G8G@lugnet.com... (...) Sure this works, but don't load it into MLCad then you get again a different view :-) Michael (23 years ago, 26-Oct-01, to lugnet.cad.mlcad)
|
|
| | Re: View matrix used for default 3D view expressed in LDLite terms
|
|
(...) Thanks! to two decimals this matches the other set given here. Appreciate the confirmation! PS I like Steve's idea! (23 years ago, 25-Oct-01, to lugnet.cad.mlcad)
|
|
| | Re: View matrix used for default 3D view expressed in LDLite terms
|
|
"Larry Pieniazek" <lpieniazek@mercator.com> wrote in message news:GLL8IB.CHF@lugnet.com... (...) selected (...) Sorry for replying so late, but I was pritty busy the last days ... MLCad uses a matrix which results from rotating over X = 23 deg., Y = (...) (23 years ago, 25-Oct-01, to lugnet.cad.mlcad)
|
|
| | Re: View matrix used for default 3D view expressed in LDLite terms [DAT]
|
|
(...) A general, reproducible, adjustable, redo-able solution to this is to write up a couple of LDLite's ROTATION commands, and then translate the commands to standard LDraw gdl. For example, to duplicate MLCAD's view, write: 0 ROTATE 23 1 0 0 0 (...) (23 years ago, 23-Oct-01, to lugnet.cad.mlcad)
|