Subject:
|
custom 73590a hose flexible
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Mon, 29 Oct 2001 21:20:06 GMT
|
Viewed:
|
2770 times
|
| |
|
|
I have been trying to make custom bent flexible hose part 73590a using parts
750 (hose flexible end 1 x 1 x2/3 with tabs) 754 (hose flexible segment link
section)755 hose flexible segment end section)and 756 hose flexible segment
centre section)
While it is possible it is very time consuming and fiddly as segments have
to be turned induvidually by fractions of degrees and move by fractions of
units.
Does anyone know of a simple way of doing this, possibly by making them
follow a spline or similar?
Tim
|
|
Message has 1 Reply:
 | | Re: custom 73590a hose flexible
|
| (...) If you know emacs, try Fredrik Glöckner's emacs ldraw mode. Even if you don't know emacs, he has good instructions at (URL) instructions for doing hoses (and bezier curves in general) are about halfway down at (URL) used it for the hoses on my (...) (23 years ago, 29-Oct-01, to lugnet.cad.mlcad)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
