| | Re: Can anyone get these parts to intersect at right angles in LDD?
|
|
(...) Gee, thanks :-) (...) free space between the black gear and the 1/2 stud bush. I've nudged things a bit and got this: (URL) wrong anyway - if you center the camera on the axle for the black wheel and zoom in, you'll see that the axle is (...) (15 years ago, 17-Jun-09, to lugnet.cad.ldd)
|
|
| | Re: Can anyone get these parts to intersect at right angles in LDD?
|
|
(...) Excellent trick, thanks for bringing it to our attention! (...) Your rotated gears seem perfectly placed, I was able to fit properly connected beams around them: (URL) it would appear that the problem is that LDD's collision engine is a bit (...) (15 years ago, 17-Jun-09, to lugnet.cad.ldd)
|
|
| | Re: Can anyone get these parts to intersect at right angles in LDD?
|
|
(...) That'd be me :-) Using the "unzip the .lxf" technique explained here... (URL) I managed to rotate and offset the bricks at will, so it's possible to position them just right. It seems that offsetting the gears by 7.5mm and 1.1mm, they seem to (...) (15 years ago, 17-Jun-09, to lugnet.cad.ldd)
|
|
| | Re: Can anyone get these parts to intersect at right angles in LDD?
|
|
"Philippe Hurbain" <philohome@free.fr> wrote in message news:KLDtB0.Bv7@lugnet.com... (...) From what I and a lurker here figured out in a few emails to each other, it would appear that the problem is that LDD's collision engine is a bit (...) (15 years ago, 17-Jun-09, to lugnet.cad.ldd)
|
|
| | Re: Can anyone get these parts to intersect at right angles in LDD?
|
|
(...) Same thing here. I was able to mesh Z36 with Z12 and "almost" z36 with z20. All other combinations that obviously works fine in real world failed. Philo (15 years ago, 17-Jun-09, to lugnet.cad.ldd)
|